Related papers: Possibility of obtaining atomic metallic hydrogen …
Atomic dark matter is usually considered to be produced asymmetrically in the early Universe. In this work, we first propose that the symmetric atomic dark matter can be thermally produced through the freeze-out mechanism. The dominant atom…
Aqueous rechargeable batteries are promising energy storage devices for the high safety, environmental friendliness, and easy assembly. However, their cycle stability and low temperature performance are limited by the narrow electrochemical…
The process of creating an atomically defined and robust metallic tip is described and quantified using measurements of contact conductance between gold electrodes and numerical simulations. Our experiments show how the same conductance…
The current energy transition imposes a rapid implementation of energy storage systems with high energy density and eminent regeneration and cycling efficiency. Metal hydrides are potential candidates for generalized energy storage, when…
High-performance anodes for rechargeable Li-ion battery are produced by nanostructuring of the transition metal oxides on a conductive support. Here, we demonstrate a hybrid material of MnO2 directly grown onto fabrics of carbon nanotube…
A three-stage metal hydride hydrogen compressor (MHHC) system based in AB2-type alloys has been set-up. Every stage can be considered as a Sieverts-type apparatus. The MHHC system can work in the pressure and temperature ranges comprised…
From first-principles calculations, we predict that a single ethylene molecule can form a stable complex with two transition metals (TM) such as Ti. The resulting TM-ethylene complex then absorbs up to ten hydrogen molecules, reaching to…
Methanol (CH3OH) is thought to form on interstellar ice dust via successive hydrogenation reactions. The reaction between CH3 and OH radicals could also conceivably generate methanol at temperatures above approximately 20 K, at which…
High-concentration aqueous electrolytes have shown promise as candidates for a safer, lower-cost battery system. Ionic conductivity is a key property required in high performing electrolytes; the Advanced Electrolyte Model (AEM) has…
This paper presents new results which may constitute a breakthrough in the effort to develop fuel cells truly suitable for use in cars and trucks. For decades, researchers have known that the alkaline fuel cell (AFC) is much cheaper to…
A rechargeable lithium metal battery (LMB), which uses metallic lithium at the anode, is among the most promising technologies for next generation electrochemical energy storage devices due to its high energy density, particularly when Li…
We discuss the formation of antihydrogen atoms ($\bar{\rm H}$) in an ultra-cold positron-antiproton plasma. For positron densities $n_p\agt 10^8$ cm$^{-3}$ the characteristic formation time of stable $\bar{H}$ is determined by collisional…
The modern means of controlled irradiation by femtosecond lasers or swift heavy ion beams can transiently produce such energy densities in samples that reach collective electronic excitation levels of the warm dense matter state where the…
Optical properties of compressed fluid hydrogen in the region where dissociation and metallization is observed are computed by ab-initio methods and compared to recent experimental results. We confirm that above 3000 K both processes are…
Atomic hydrogen cleaning followed by heat cleaning at 450$^\circ$C was used to prepare negative-electron-affinity GaAs photocathodes. When hydrogen ions were eliminated, quantum efficiencies of 15% were obtained for bulk GaAs cathodes,…
We present a theoretical and numerical scheme that enables quantifying hydrogen ingress in metals for arbitrary environments and defect geometries. This is achieved by explicitly resolving the electrochemical behaviour of the electrolyte,…
Ammonium tetrathiomolybdate (ATM) spontaneously self assembles on Au electrodes forming a hydrophilic, air stable, pH (3-11) tolerant multilayer that is stable over a reasonably large potential window. The ATM functionalized Au electrodes…
The interaction between hydrogen atoms and carbon nanoparticles is a fundamental process governing the properties of carbonaceous materials in environments ranging from combustion systems to the interstellar medium. This study investigates…
We have studied solid hydrogen under pressure at low temperatures. With increasing pressure we observe changes in the sample, going from transparent, to black, to a reflective metal, the latter studied at a pressure of 495 GPa. We have…
As a new type of self-healing material, room-temperature liquid metal (LM) composed of Ga, In and Sn is a promising anode in lithium-ion batteries (LIBs). It is difficult to directly prepare an electrode slurry with pure LM. Here, the LM…