Related papers: Semiconductor solar superabsorber
A metamaterial perfect absorber consisting of a tri-layer (Al/ZnS/Al) metal-dielectric-metal system with top aluminium nano-disks is fabricated by laser-interference lithography and lift-off processing. The metamaterial absorber had peak…
The trapped rainbow effect has been mostly found on tapered anisotropic metamaterials (MMs) made of low loss noble metals, such as gold, silver, etc. In this work, we demonstrate that an anisotropic MM waveguide made of high loss metal…
We present a general principle for the rational design of dielectric optical antennas with optimal solar absorption enhancement: leaky mode engineering. This builds upon our previous study that demonstrates the solar absorption of a…
A high photon to electricity conversion efficiency of 47.2082% was achieved by a novel combination of In0.51Ga0.49P, GaAs, In0.24Ga0.76As and In0.19Ga0.81Sb subcell layers in a quadruple junction solar cell design. The electronic bandgap of…
Since the photoconversion efficiency $\eta$ of the silicon-based solar cells (SCs) under laboratory conditions is approaching the theoretical fundamental limit, further improvement of their performance requires theoretical modeling and/or…
Superconducting radiation detectors typically exhibit detection and single photon sensitivity limited to the mid infrared wavelength range. Extending their detection capabilities into the far infrared range (>10 um) requires careful…
Luminescent solar concentrator (LSC) can absorb large-area incident sunlight, then emit luminescence with high quantum efficiency, which finally be collected by a small photovoltaic (PV) system. The light-harvesting area of the PV system is…
Based on fundamental properties of light scattering by a particle we reveal the existence of the ultimate upper limit for the light absorption by any partial mode. First, we obtain this result for scattering of a plane wave by a symmetric…
Solar cells have generated a lot of interest as a potential source of clean renewable energy for the future. However a big bottleneck in wide scale deployment of these energy sources remain the low efficiency of these conversion devices.…
Elementary semiconductors are rare and attractive, especially for low-dimensional materials. Unfortunately, most of boron nanostructures were found to be metallic, despite of their typical semiconducting bulk structure. Herein, we propose a…
Near-perfect absorbers (NPAs) efficiently absorb visible light with a layered nanostructure that is thinner than the diffusion lengths of photogenerated charge carriers. We overcame existing limitations in fabricating their nanoparticulate…
A finite element-based modal formulation of diffraction of a plane wave by an absorbing photonic crystal slab of arbitrary geometry is developed for photovoltaic applications. The semi-analytic approach allows efficient and accurate…
We systematically investigate the optical behaviors of an amorphous silicon solar cell based on a core-shell nanograting structure. The horizontally propagating Bloch waves and Surface Plasmon Polariton (SPP) waves lead to significant…
When the sulfur element is hyperdoped into crystalline silicon to a supersaturated density of 1020 cm-3, it can enhance the sub-bandgap light absorption of silicon from 0 to 70%, with the antireflection of surface dome structures. On the…
All light has structure, but only recently it has become possible to construct highly controllable and precise potentials so that most laboratories can harness light for their specific applications. In this chapter, we review the emerging…
The Shockley and Queisser limit, a well-known efficiency limit for a solar cell, is based on unrealistic physical assumptions and its maximum limit is seriously overestimated. To understand the power loss mechanisms of record-efficiency…
The rigorous coupled-wave approach (RCWA) and the differential evolution algorithm (DEA) were coupled in a practicable approach to maximize absorption in optical structures with three-dimensional morphology. As a model problem, optimal…
Selenium, the world's oldest photovoltaic material, has experienced a renaissance in research over the past decade, with certified solar cell efficiencies climbing from the historical record of 5% to breaking the 10% barrier. Its wide…
Synthetic perovskites with photovoltaic properties open a new era in solar photovoltaics. Due to high optical absorption perovskite-based thin-film solar cells are usually considered as fully absorbing solar radiation on condition of ideal…
Inelastic scattering and carrier capture by defects in semiconductors are the primary causes of hot-electron-mediated degradation of power devices, which holds up their commercial development. At the same time, carrier capture is a major…