Related papers: FPGA based data acquisition system for COMPASS exp…
We have developed a novel data acquisition system for measuring tracking parameters of a silicon detector in a particle beam. The system is based on a commercial Analog-to-Digital VME module and a PC Linux based Data Acquisition System.…
The new Data Acquisition system for the gravitational wave detector AURIGA has been designed from the ground up in order to take advantage of hardware and software platforms that became available in recent years; namely, i386 computers…
J-PARC E16 is an experiment to examine the origin of hadron mass through a systematic measurement of spectral changes of vector mesons in nuclei. The measurement of $e^{+}e^{-}$ pairs from the decay of vector mesons will provide the…
We present the design and first test results of a new FADC-based data acquisition (DAQ) system for the Grande array of the KASCADE-Grande experiment. The original KASCADE experiment at the Forschungszentrum Karlsruhe, Germany, has been…
This paper presents the design and implementation of the front-end electronics and the data acquisition (DAQ) system for readout of multi-wire drift chambers (MWDC). Apart of the conventional drift time measurement the system delivers the…
The aim of the project was to develop a HMI (Human-Machine Interface) with the help of which a person could remotely control and monitor the Vacuum measurement system. The Vacuum measurement system was constructed using a DAQ (Data…
CBM (Compressed Baryonic Matter) is mainly used to study QCD phase diagram of strong interactions in high and moderate temperature region. Before the next generation GBTx based CBM DAQ system is built up, the DPB (Data Processing Board)…
Although software and firmware co-simulation is gaining popularity, it is still not widely used in the FPGA designs. This work presents easy and structured approach for software and firmware co-simulation for bus centric designs. The…
Electronic systems for qubit control and measurement serve as a bridge between quantum programming language and quantum information processors. With the rapid development of superconducting quantum circuit (SQC) technology, synchronization…
This paper presents FADE-10G - an integrated solution for modern multichannel measurement systems. Its main aim is a low latency, reliable transmission of measurement data from FPGA-based front-end electronic boards (FEBs) to a…
The XENON1T liquid xenon time projection chamber is the most sensitive detector built to date for the measurement of direct interactions of weakly interacting massive particles with normal matter. The data acquisition system (DAQ) is…
The WaveDAQ is a newly-designed digitization Trigger and Data AcQuisition system (TDAQ) allowing Multi-gigasample waveform recording on a large amount of channels (up to 16384) by using the DRS4 analog switched capacitor array as…
XDAQ is a generic data acquisition software environment that emerged from a rich set of of use-cases encountered in the CMS experiment. They cover not the deployment for multiple sub-detectors and the operation of different processing and…
This paper presents a system consisting of the FPGA IP core, the simple network protocol and the Linux device driver, capable of efficient and reliable data transmission from a low resources FPGA chip to the Linux-based embedded computer…
A new TDC-chip is under development for the COMPASS experiment at CERN. The ASIC, which exploits the 0.6 micrometer CMOS sea-of-gate technology, will allow high resolution time measurements with digitization of 75 ps, and an unprecedented…
Identifying the state of a quantum bit (qubit), known as quantum state discrimination, is a crucial operation in quantum computing. However, it has been the most error-prone and time-consuming operation on superconducting quantum…
The Detector Control System (DCS) of the COMPASS experiment at CERN is presented. The experiment has a high level of complexity and flexibility and a long time of operation, that constitute a challenge for its full monitorisation and…
The Real-Time Systems Engineering Department of the Scientific Computing Division at Fermilab has deployed set of customizations to our Off-The-Shelf Data Acquisition solution (otsdaq) at the Fermilab Test Beam Facility (FTBF) to read out…
A very simple Data acquisition card was developed in our under-graduate class for interfacing with the parallel port of a standard computer. It was developed with the intention to enable students to do various physics experiments with the…
Structural vibration testing plays a key role in aerospace engineering for evaluating dynamic behaviour, ensuring reliability and verifying structural integrity. These tests rely on accurate and robust data acquisition systems (DAQ) to…