Related papers: Cavity optomechanics in gallium phosphide microdis…
Chip-based cavity optomechanical systems are being considered for applications in sensing, metrology, and quantum information science. Critical to their development is an understanding of how the optical and mechanical modes interact,…
Second harmonic conversion from 1550~nm to 775~nm with an efficiency of 400% W$^{-1}$ is demonstrated in a gallium phosphide (GaP) on oxide integrated photonic platform. The platform consists of doubly-resonant, phase-matched ring…
At low temperatures, microwave cavities are often preferred for the readout and control of a variety of systems. In this paper, we present design and measurements on an optomechanical device based on a 3-dimensional rectangular waveguide…
We present the results of theoretical and experimental studies of dispersively coupled (or "membrane in the middle") optomechanical systems. We calculate the linear optical properties of a high finesse cavity containing a thin dielectric…
Cavity-enhanced radiation-pressure coupling of optical and mechanical degrees of freedom gives rise to a range of optomechanical phenomena, in particular providing a route to the quantum regime of mesoscopic mechanical oscillators. A prime…
GaAs disk resonators (typical disk size 5 \mum * 200 nm in our work) are good candidates for boosting optomechanical coupling thanks to their ability to confine both optical and mechanical energy in a sub-micron interaction volume. We…
Long-storage-time Fabry-Perot cavities are a core component of many precision measurement experiments. Optical loss in such cavities is a critical parameter in determining their performance; however, it is very difficult to determine a…
The quality factor (Q), mode volume (Veff), and room-temperature lasing threshold of microdisk cavities with embedded quantum dots (QDs) are investigated. Finite element method simulations of standing wave modes within the microdisk reveal…
We experimentally study an optomechanical cavity consisting of an oscillating mechanical resonator embedded in a superconducting microwave transmission line cavity. Tunable optomechanical coupling between the mechanical resonator and the…
Currently, optical- or mechanical-resonances are commonly used in microfluidic research. However, optomechanical oscillations by light pressure were not shown with liquids. This is because replacing the surrounding air with water inherently…
Radiation pressure, electrostriction, and photothermal forces have been investigated to evidence backaction, non-linearities and quantum phenomena in cavity optomechanics. We show here through a detailed study of the relative intensity of…
We present the design of an optomechanical crystal nanobeam cavity that combines finite-element simulation with numerical optimization, and considers the optomechanical coupling arising from both moving dielectric boundaries and the…
Whispering gallery modes in GaAs disk resonators reach half a million of optical quality factor. These high Qs remain still well below the ultimate design limit set by bending losses. Here we investigate the origin of residual optical…
We investigate the optomechanical properties of tensile-strained ternary InGaP nanomembranes grown on GaAs. This material system combines the benefits of highly strained membranes based on stoichiometric silicon nitride, with the unique…
The topic of this thesis is the theoretical analysis of the optomechanical coupling effects in a high-finesse optical cavity, and the experimental realization of such a device. Radiation pressure exerted by light limits the sensitivity of…
Periodically structured materials can sustain both optical and mechanical excitations which are tailored by the geometry. Here we analyze the properties of dispersively coupled planar photonic and phononic crystals: optomechanical crystals.…
Surface acoustic waves (SAWs) coupled to quantum dots (QDs), trapped atoms and ions, and point defects have been proposed as quantum transduction platforms, yet the requisite coupling rates and cavity lifetimes have not been experimentally…
Thin GaP films can be grown on an exact Si(001) substrate with nearly perfect lattice match. We perform all-optical pump-probe measurements to investigate the ultrafast electron-phonon coupling at the buried interface of GaP/Si.…
Intracavity squeezing is a promising technique that may improve the sensitivity of gravitational wave detectors and cool optomechanical oscillators to the ground state. However, the photothermal effect may modify the occurrence of…
Cavity optomechanical systems have become a popular playground for studies of controllable nonlinear interactions between light and motion. Owing to the large speed of light, realizing cavity optomechanics in the microwave frequency range…