Related papers: Suppression of amplitude-to-phase noise conversion…
We present an optical frequency divider based on a 200 MHz repetition rate Er:fiber mode-locked laser that, when locked to a stable optical frequency reference, generates microwave signals with absolute phase noise that is equal to or…
We demonstrate ultralow phase noise 10-GHz microwave signal generation from a free-running mode-locked Er-fiber laser with -142 and -157 dBc/Hz single-sideband absolute phase noise at 10- and 100-kHz offset frequencies, respectively. The…
We report a simple technique to suppress high frequency phase noise of a Yb-based fiber optical frequency comb using an active intensity noise servo. Out-of-loop measurements of the phase noise using an optical heterodyne beat with a…
We report what we believe to be the lowest phase noise optical-to-microwave frequency division using fiber-based femtosecond optical frequency combs: a residual phase noise of -120dBc/Hz at 1 Hz offset from a 11.55GHz carrier frequency. We…
We synchronize a 8.06-GHz microwave signal from a voltage-controlled oscillator with an optical pulse train from a 77.5- MHz mode-locked Er-fiber laser using a fiber-based optical-microwave phase detector. The residual phase noise between…
We report ultra-low phase-noise microwave generation at a 9.6 GHz carrier frequency from optical frequency combs based on diode-pumped solid-state lasers emitting at telecom wavelength and referenced to a common cavity-stabilized…
In this letter, we report on all-optical fiber approach to the generation of ultra-low noise microwave signals. We make use of two erbium fiber mode-locked lasers phase locked to a common ultra-stable laser source to generate an 11.55 GHz…
Coherent frequency division of high-stability optical sources permits the extraction of microwave signals with ultra-low phase noise, enabling their application to systems with stringent timing precision. To date, the highest performance…
We characterize the phase noise of a microwave photonic channel, where a 10 GHz signal is carried by an intensity-modulated light beam over a short optical fiber, and detected. Two options are compared, (i) an electro-optic modulator (EOM),…
Phase noise can be modulated onto the output of a laser with an electro-optic phase modulator (EOM) to create a highly incoherent broadened source with low intensity noise. This technique leaves a small but finite fraction of the coherent…
We use two fiber-based femtosecond frequency combs and a low-noise carrier suppression phase detection system to characterize the optical to microwave synchronization achievable with such frequency divider systems. By applying specific…
In this paper, we present a very simple design based on commercial devices for the all-optical generation of ultra-low phase noise microwave signals. A commercial, fibered femtosecond laser is locked to a laser that is stabilized to a…
We describe and characterize a simple, low cost, low phase noise microwave source that operates near 6.800 GHz for agile, coherent manipulation of ensembles of 87Rb. Low phase noise is achieved by directly multiplying a low phase noise 100…
We demonstrate a Raman laser system based on phase modulation technology and phase feedback control. The two laser beams with frequency difference of 6.835 GHz are modulated using electro-optic and acousto-optic modulators, respectively.…
We investigate the impact of pulse interleaving and optical amplification on the spectral purity of microwave signals generated by photodetecting the pulsed output of an Er:fiber-based optical frequency comb. It is shown that the microwave…
Compact, ultra-low phase noise 10 GHz signals are essential for modern radar, coherent communications, and time-frequency metrology, especially with rising demands for additional spectral purity and portability. Optical frequency division…
The generation of microwaves from optical signals suffers from thermal and shot noise inherent in the photodetection process. This problem is more acute at lower pulse repetition rates where photodiode saturation limits the achievable…
We describe the design of a low-phase-modulated (PM) noise, 40 GHz oscillator that uses a conventional air-dielectric cavity resonator as a frequency discriminator to improve the PM noise of a commercial 10 GHz dielectric resonator…
This contribution focuses on phase-noise added during frequency conversion in low-level radio frequency (LLRF) control systems. The stability of beams' parameters in linear accelerators depends on the stability of amplitude and phase of the…
In this paper, we report a new scheme to amplify a microwave signal carried on a laser light at $\lambda$=852nm. The amplification is done via a semiconductor tapered amplifier and this scheme is used to drive stimulated Raman transitions…