Related papers: Stress Evolution in Composite Silicon Electrodes d…
It is generally believed that silicon-based anodes for Li-ion batteries would benefit from stronger binders, as cyclic volume changes would not disrupt the cohesion of the composite electrode. Here, we put this belief to the proof by…
This study is concerned with modeling detrimental deformations of the binder phase within lithium-ion batteries that occur during cell assembly and usage. A two-dimensional poroviscoelastic model for the mechanical behavior of porous…
It is shown that continuously occurring electrolyte-reduction reaction on freshly-exposed electrode surfaces during lithiation/delithiation cycles causes the lowering of cycling efficiency, and hence, capacity fade in well-cycled silicon…
The large volume change of the silicon (Si) during lithiation and delithiation process has long been a problem impeding its application as one of the most promising anode materials for LIBs. In this paper, we proposed a conceptually new…
Crystalline materials exhibit an hysteresis behaviour when deformed cyclically. The origins of this tension-compression asymmetry have been fully understood only recently as being caused by an asymmetry in the junction strength and a…
Despite ongoing efforts aimed at increasing energy density in all-solid-state-batteries, the optimal composite cathode morphology, which requires minimal volume change, small void development, and good interfacial contact, remains a…
During electrostatic bonding, also known as anodic bonding, silicon is bonded to glass by applying an external voltage and simultaneous heating to temperatures of 200...450 $\deg$C. While cooling to working temperature after bonding…
A combination of micro-Raman spectroscopy and micro-XPS (X-ray photo-electron spectroscopy) mapping on statically deflected p-type silicon cantilevers is used to study the mechanical stress dependence of the Fermi level pinning at an…
Shear stresses are the driving forces for the creation of both point and extended defects in crystals subjected to high pressures and temperatures. Recently, we observed anomalous elastic materials response in shock-compressed silicon and…
Solid-state lithium batteries possess numerous advantages, such as high energy density, excellent cycle stability, superior mechanical strength, non-flammability, enhanced safety, and extended service life. These characteristics make them…
Silicon (Si) is one of the most abundant elements on Earth, and it is the most important and widely used semiconductor, constituting the basis of modern electronic devices. Despite extensive study, some properties of Si remain elusive. For…
Systematic measurements of stress impedance (SI) and magneto-impedance (MI) have been carried out using Co-rich amorphous ribbons of nominal composition Co71-xFexCr7Si8B14 (x = 0, 2) at various excitation frequencies and bias fields and at…
The relaxation dynamics of hot carriers in silicon (100) is studied via a novel holistic approach based on phase-resolved transient absorption spectroscopy with few-cycle optical pulses. After excitation by a sub-5 fs light pulse, strong…
Next-generation lithium-ion batteries with silicon anodes have positive characteristics due to higher energy densities compared to state-of-the-art graphite anodes. However, the large volume expansion of silicon anodes can cause high…
Crystal structures of $\textrm{CLi}_4$ compounds are explored through \emph{ab} \emph{initio} evolutionary methodology. Phase transition from metal to semimetal and semiconductor, and eventually to insulator with increasing pressure are…
Silicon offers great promise as a potential anode active material and the optimum alternative to lithium metal in all-solid-state lithium-ion batteries. However, its practical application is limited by severe volume expansion (~300%) during…
Beyond active material intrinsic properties, the electrode manufacturing process is a crucial step to reach high energy density and long-life of Li-ion batteries. In particular, very high pressures are applied to the electrode during the…
Through advanced experimental techniques on CrI$_{3}$ single crystals, we derive a previously not discussed pressure-temperature phase diagram. We find that $T_{c}$ increases to $\sim$ 66\,K with pressure up to $\sim$ 3\,GPa followed by a…
We have explored isotropically jammed states of semi-2D granular materials through cyclic compression. In each compression cycle, systems of either identical ellipses or bi-disperse disks, transition between jammed and unjammed states. We…
Compression experiments are widely used to study the mechanical properties of materials at micro- and nanoscale. However, the conventional engineering stress measurement method used in these experiments neglects to account for the…