Related papers: 217 km long distance photon-counting optical time-…
We implement a photon-counting Optical Time Domain Reflectometer (OTDR) at 1.55um which exhibits a high 2-point resolution and a high accuracy. It is based on a low temporal-jitter photon-counting module at 1.55um. This detector is composed…
Single photon detector (SPD) has a maximum count rate due to its dead time, which results in that the dynamic range of photon counting optical time-domain reflectometry (PC-OTDR) de-creases with the length of monitored fiber. To further…
We demonstrate optical time domain reflectometry over 200 km of optical fiber using low-noise NbTiN superconducting single-photon detectors integrated with Si3N4 waveguides. Our small detector footprint enables high timing resolution of…
A direct-detection Brillouin optical time-domain reflectometry (BOTDR) is proposed and demonstrated by using an up-conversion single-photon detector and a fiber Fabry-Perot scanning interferometer (FFP-SI). Taking advantage of high…
We consider the use of single-photon counting detectors in coherence-domain imaging. Detectors operated in this mode exhibit reduced noise, which leads to increased sensitivity for weak light sources and weakly reflecting samples. In…
By means of C-OTDR (Correlation - Optical Time Domain Reflectometry), we measured the latency of100 km fiber with an accuracy of a few picoseconds. Based on iterating 49 measurements, we calculated a standard deviation of 12 ps between the…
We present a novel distributed Brillouin optical time domain reflectometer (BOTDR) using standard telecommunication fibers based on single-photon avalanche diodes (SPADs) in gated mode, hd-BOTDR, with a range of 120 km and 10 m spatial…
A correlation optical time-domain reflectometry (COTDR) method is presented, which measures the propagation delay with an accuracy of a few picoseconds. This accuracy is achieved using a test signal data rate of 10 Gbit/s and employing…
A long range phase-sensitive optical time domain reflectometer (phi-OTDR) with a multi-frequency non-linear frequency modulation (NLFM) optical pulse is proposed in this Letter. To boost the pulse energy while suppressing the optical…
In the maintenance of optical fiber networks, there is a growing demand for high-precision measurement of optical loss distribution and fault locations over long distances. In this study, we propose an OCDR method incorporating periodic…
We have demonstrated upconversion detection at the single photon level in the 2 um spectral window using a pump wavelength near 1550nm, a periodically poled lithium niobate (PPLN) waveguide, and a volume Bragg grating (VBG) to reduce noise.…
We demonstrate upconversion single-photon detection for the 1550-nm band using a PPLN waveguide, long-wavelength pump, and narrowband filtering using a volume Bragg grating. We achieve total-system detection efficiency of around 30% with…
Photon counting optical time-domain reflectometry (PC-OTDR) based on the single photon detection is an effective scheme to attain the high spatial resolution for optical fiber fault monitoring. Currently, due to the spatial resolution of…
Optical time-domain reflectometry (OTDR) is the basis for distributed time-domain optical fiber sensing techniques. By injecting pulse light into an optical fiber, the distance information of an event can be obtained based on the time of…
We demonstrate an experimental phase optical time-domain reflectometry (OTDR) system capable of simultaneous detection and classification of various environmental events, such as wind-induced fiber movement, vehicle movement, and audio…
We develop single-photon detectors comprising single-mode fiber-coupled superconducting nanowires, with high system detection efficiencies at a wavelength of 940 nm. The detector comprises a 6.5-nm-thick, 110-nm-wide NbN nanowire meander…
Supervision of the physical layer of optical networks is an extremely relevant subject. To detect fiber faults, single-ended solutions such as the Optical Time Domain Reflectometer (OTDR) allow for precise measurements of fault profiles.…
Optical time-domain reflectometry (OTDR) has been widely used for characterizing fiber optical links and for detecting and locating fiber faults. OTDR traces are prone to be distorted by different kinds of noise, causing blurring of the…
Superimposed temperature variations and dynamic strain applied through a 400 Hz acoustic signal on a 195 m single-mode fiber section are successfully measured using a coherent correlation optical time domain reflectometry as an…
To address the challenges associated with shape sensing of continuum manipulators (CMs) using Fiber Bragg Grating (FBG) optical fibers, we feature a unique shape sensing assembly utilizing solely a single Optical Frequency Domain…