Related papers: Recent RHIC in-situ coating technology development…
Microscale additive manufacturing of reflective copper is becoming increasingly important for microelectronics and microcomputers, due to its excellent electrical and thermal conductivity. Yet, it remains challenging for state-of-the-art…
We present a method to measure the absolute surface resistance of conductive samples at a set of GHz frequencies with superconducting lead stripline resonators at temperatures 1- 6K. The stripline structure can easily be applied for bulk…
The secondary emission yield (SEY) properties of colaminated Cu samples for LHC beam screens are correlated to the surface chemical composition determined by X-ray photoelectron spectroscopy. The surface of the "as received" samples is…
We have prepared the new amorphous superconductor $\rm Mo_xC_yGa_zO_{\delta}$ with a maximum critical temperature $T_c$ of 3.8\,K by the direct-write nano-patterning technique of focused (gallium) ion beam induced deposition (FIBID) using…
We demonstrate the imaging of ferromagnetic carbon steel samples and we detect the thinning of their profile with a sensitivity of 0.1 mm using a Cs radio-frequency atomic magnetometer. Images are obtained at room temperature, in…
Cubic GaN layers were grown by plasma-assisted molecular beam epitaxy on 3C-SiC (001)substrates. In situ reflection high energy electron diffraction was used to quantitatively determine the Ga coverage of the GaN surface during growth.…
Highly crystalline and easily feasible topological insulator-superconductor (TI-SC) heterostructures are crucial for the development of practical topological qubit devices. The optimal superconducting layer for TI-SC heterostructures should…
Performances of several single gap (gas gap 2 mm) prototype Resistive Plate Chambers (RPC) made of high resistive ({\rho} \sim 1010 - 1012 {\Omega} cm) bakelite, commercially available in India have been studied in recent times. To make the…
The chemical interaction between Mo and Ru layers in multilayer structures depending on the thickness ratio ($\Gamma$) was carried out using X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD) and X-ray reflectometry (XRR). The…
Ti/Al multilayer thin films with precise thickness have been deposited using a combination of dc and rf magnetron sputtering techniques. Cross-sectional transmission electron microscopy (TEM) revealed unmixed fifteen parallel and alternate…
In this study, a preparation route of Co-Cu alloys with soft magnetic properties by high-pressure torsion deformation is introduced. Nanocrystalline, supersaturated single-phase microstructures are obtained after deformation of Co-Cu…
The changes of magnetic properties upon heat treatment of a metastable supersaturated solid solution processed by severe plastic deformation are investigated by in-situ AC-hysteresis measurements. Data are analyzed in the framework of…
A hydrostatic pressure study was made on pure and Rh-doped specimens of the superconducting ferromagnetic compounds Ru1-xRhxSr2GdCu2O8 (x = 0-0.15) by means of measurement of electrical resistivity vs temperature, in pressures up to 2 GPa.…
In situ Electro-Chemical Scanning Tunneling Microscopy (ECSTM) and Electron Back-Scatter Diffraction analysis of the same local microstructural region were combined to study the relationships between grain boundary (GB) type and structure…
Resistive Plate Chambers (RPCs) are essential active media of large-scale experiments as part of the muon systems and (semi-)digital hadron calorimeters. Among the several outstanding issues associated with the RPCs, the loss of efficiency…
RF sputtered ZnO and Al:ZnO films are attractive transparent conductive oxides for fabrication of opto-electronic devices. In this paper we present efforts to control carrier concentration and mobility of ZnO/Al:ZnO thin films by…
Future laser-interferometric gravitational wave detectors (GWDs) will potentially employ test mass mirrors from crystalline silicon and a laser wavelength of $1550\,\rm{nm}$, which corresponds to a photon energy below the silicon bandgap.…
Vapor cells with antirelaxation coating are widely used in modern atomic physics experiments due to the coating's ability to maintain the atoms' spin polarization during wall collisions. We characterize the performance of vapor cells with…
The objective of this work was to study the RF sputtering process parameters optimisation for deposition of Silicon Nitride thin films. The process parameters chosen to be varied were deposition power, deposition duration, flow rate of…
Hydrogenated amorphous silicon alloy films are generally deposited by radio frequency plasma enhanced chemical vapor deposition (RF PECVD) technique on various types of substrates. Generally it is assumed that film quality remains unchanged…