Related papers: Titanium dioxide (TiO2) Nanoparticles XRD Analyses…
VO2 is a much-discussed material for oxide electronics and neuromorphic computing applications. Here, heteroepitaxy of vanadium dioxide (VO2) was realized on top of oxide nanosheets that cover either the amorphous silicon dioxide surfaces…
Topography of silicon surfaces irradiated by a 2 MeV Si$^+$ ion beam at normal incidence and ion fluences in the range $10^{15}-10^{16}$ ions/cm$^{2}$ has been investigated using scanning tunneling microscopy. At length scales below…
Using a thermal-chemical model for the generic T-Tauri disk of D'Alessio et al. (1999), we estimate the strength of the fine-structure emission lines of NeII and NeIII at 12.81 and 15.55 microns that arise from the warm atmosphere of the…
Iron oxide nano particles with nominal Fe2O3 stoichiometry were synthesized by a wet, soft chemical method with the heat treatment temperatures from 250{\deg}C to 900{\deg}C in air. The variation in the structural properties of the nano…
Cu-Sn-Zn coatings have been widely used in industry for their unique properties, such as good conductivity, high corrosion resistance and excellent solderability. To further improve the mechanical performance of Cu-Sn-Zn coatings,…
Ferroelectric materials display exotic polarization textures at the nanoscale that could be used to improve the energetic efficiency of electronic components. The vast majority of studies were conducted in two dimensions on thin films, that…
The hydrothermal carbonation of calcium hydroxide (Ca(OH)2) at high pressure of CO2 (initial PCO2 1/4 55 bar) and moderate to high temperature (30 and 90 1C) was used to synthesize fine particles of calcite. This method allows a high…
We study the interface between carbon nanotubes (CNTs) and surface-deposited titanium using electron microscopy and photoemission spectroscopy, supported by density functional calculations. Charge transfer from the Ti atoms to the nanotube…
The surfaces of metal oxides often are reconstructed with a geometry and composition that is considerably different from a simple termination of the bulk. Such structures can also be viewed as ultrathin films, epitaxed on a substrate. Here,…
Manganese dioxide nanorods were synthesized using novel solution route. The phase and microstructure of synthesized materials were identified using X ray diffraction, scanning electron and transmission electron microscopic measurements. The…
Well-separated mercury sulfide (HgS) nanocrystals are synthesized by a wet chemical route. Transmission electron microscopy studies show that nanocrystals are nearly spherical in shape with average size of 9 nm. Grazing angle X-ray…
The structural and electrical properties of Ti-N films deposited by reactive sputtering depend on their growth parameters, in particular the Ar:N2 gas ratio. We show that the nitrogen percentage changes the crystallographic phase of the…
The optical properties of metallic tin nanoparticles embedded in silicon-based host materials were studied. Thin films containing the nanoparticles were produced using RF magnetron sputtering followed by ex situ heat treatment. Transmission…
We analyze the results of scanning near-field infrared spectroscopy performed on thin films of a-SiO2 on Si substrate. The measured near-field signal exhibits surface-phonon resonances whose strength has a strong thickness dependence in the…
Using electron diffraction on free-standing single-walled carbon nanotubes we have determined the structural indices (n,m) of tubes in the diameter range from 1.4 to 3nm. On the same free-standing tubes we have recorded Raman spectra of the…
We used by in-situ high energy X-ray diffraction to inestigate the deformation behavior of Grade 2 commercially pure titanium that was hydrogen charged to form hydrides. The results showed that the peak broadening in the diffraction…
Titanium dioxide materials have been studied intensively and extensively due to photocatalytic applications. A long-standing open question is the energy band alignment of rutile and anatase TiO2 phases, which can affect the photocatalytic…
Titanium dioxide has been extensively studied in the rutile or anatase phases, while its high-pressure phases are less well understood, despite that many are thought to have interesting optical, mechanical and electrochemical properties.…
Bi-directional reflection spectroscopy based on multiple scattering of particulate surfaces is employed in identifying the optical properties of titanium-iron oxide mineral from laboratory reflection measurements.However, the approach…
The quest of a nonlinear optical material that can be easily nanostructured over a large surface area is still ongoing. Here, we demonstrate a nanoimprinted nonlinear barium titanate 2D nanohole array that shows optical properties of a 2D…