Related papers: Characterisation of local ICRF heat loads on the J…

The major aspects linked to the use of the JET auxiliary heating systems: NBI, ICRF and LHCD, in the new JET ITER-like wall (JET-ILW) are presented. We show that although there were issues related to the operation of each system, efficient…

The replacement of the JET carbon wall (C-wall) by a Be/W ITER-like wall (ILW) has affected the plasma energy confinement. To investigate this, experiments have been performed with both the C-wall and ILW to vary the heating power over a…

In this paper important aspects of Lower Hybrid (LH) operation with the ITER Like Wall (ILW) [1] at JET are reported. Impurity release during LH operation was investigated and it was found that there is no significant Be increase with LH…

The ITER Ion Cyclotron Resonance Heating (ICRH) system is designed to couple to the plasma 20 MW of RF power from two antennas in the 40-55 MHz frequency range during long pulses of up to 3600 s and under various plasma conditions with Edge…

Measurements are reported of electromagnetic emission close to the cyclotron frequency of energetic ions in JET plasmas heated by waves in the ion cyclotron range of frequencies (ICRF). Hydrogen was the majority ion species in all of these…

Gas-puff imaging techniques are employed to determine the far SOL region radial electric field and the plasma potential in ICRF heated discharges in the Alcator C-Mod tokamak. The 2-dimensional velocity fields of the turbulent structures,…

This paper compares the gyrokinetic instabilities and transport in two representative JET pedestals, one (pulse 78697) from the JET configuration with a carbon wall (C) and another (pulse 92432) from after the installation of JET's…

The design of the WEST (Tungsten-W Environment in Steady-state Tokamak) Ion cyclotron resonance heating antennas is based on a previously tested conjugate-T Resonant Double Loops prototype equipped with internal vacuum matching capacitors.…

Ion Cyclotron Range of Frequencies (ICRF) heating is essential for creating plasma in next-generation fusion devices. ICRF antennas often produce hot spots, reducing reliability, material survivability, and overall plasma performance. We…

The ITER ICRF system will gain in complexity relative to the existing systems on modern devices, and the same will hold true for DEMO. The accumulated experience can help greatly in designing an ICRF system for DEMO. In this paper the…

In magnetic fusion experiments, a simple technique to evaluate the heat flux on first wall components is a key to controlled plasma surface interaction. The heat flux can be characterized by the peaking factor which is the ratio of the peak…

A global heat flux model based on a fractional derivative of plasma pressure is proposed for the heat transport in fusion plasmas. The degree of the fractional derivative of the heat flux, $\alpha$, is defined through the power balance…

Circularly polarized waves consistent with parallel-propagating ion cyclotron waves (ICWs) and fast magnetosonic waves (FMWs) are often observed by Parker Solar Probe (PSP) at ion kinetic scales. Such waves damp energy via the cyclotron…

We present a computational study of isochoric heating in multi-layered targets at ultra-high intensity laser irradiation (approx. 10**20 W/cm**2). Previous studies have shown enhanced ion heating at interfaces, but at the cost of large…

The Inner First Wall (IFW) is the main limiter in Tore Supra for long and powerful discharges. The original graphite IFW was partly damaged by 8 years of operation and a sector of 60{\textdegree} was replaced between 1995 and 1997 by CFC…

The paper is devoted to the investigation of the turbulent water boundary layer in the jet mixing flows using high-speed infrared (IR) thermography. Two turbulent mixing processes were studied: a submerged water jet impinging on a flat…

Electron heating and ionization dynamics in capacitively coupled radio frequency (RF) atmospheric pressure microplasmas operated in helium are investigated by Particle in Cell simulations and semi-analytical modeling. A strong heating of…

Ion energy measurements have been made in the scrape off layer of the Mega Amp Spherical Tokamak (MAST) using a midplane retarding field energy analyser (RFEA) in H-mode plasmas during the inter-edge localised mode (ELM) period and during…

The Travelling Wave Array (TWA) antenna was proposed as a promising alternative for Ion Cyclotron Resonant Heating (ICRH) in future fusion reactors. In this study, the possibility to make a TWA compatible with a tungsten environment like…

Embedded RF contacts are integrated within the ITER ICRH launcher to allow assembling, sliding and to lower the thermo-mechanical stress. They have to withstand a peak RF current up to 2.5 kA at 55 MHz in steady-state conditions, in the…