Related papers: The Summary for Optimization of the Annular Couple…

In this paper, we give some guidelines for the design of linear accelerators, with special emphasis on their use in a hadron therapy facility. We concentrate on two accelerator layouts, based on linacs. The conventional one based on a linac…

Since 2006, there have been unexpected trigger-failure events during the operation of the Japan Proton Accelerator Research Complex (J-PARC) timing system. However, among the many suspected modules, it has been difficult to find the one…

The new 1.4 MeV/u front end HSI (HochStromInjektor) of the Unilac accelerates ions with A/q ratios of up to 65 and with beam intensities in emA of up to 0.25 A/q. The maximum beam pulse power is up to 1300 kW. During the stepwise linac…

Preinjector VEPP-5 electron linac consists of two linear accelerators on energy 300 MeV and 510 MeV and includes 14 accelerating structures [1]. First accelerating structures both linacs have increased average rate of acceleration 25-30…

During the operation of the China ADS Front End Superconducting Demo Linac of the China initiative Accelerator Driven System (CiADS), it was found that there was flashover happened on the surface of vacuum ceramic window in the pick-up…

In uplink integrated sensing and communication (ISAC) systems, pilot signal design is crucial for enabling accurate channel estimation and reliable radar sensing. In orthogonal frequency-division multiple access (OFDMA)-based frameworks,…

This paper presents a cross-layer approach to jointly design adaptive modulation and coding (AMC) at the physical layer and cooperative truncated automatic repeat request (ARQ) protocol at the data link layer. We first derive an exact…

Main parameters of linac-ring type $phi$-factory proposed as the part of the Turkic Accelerator Complex (TAC) in the framework of ATAM Science Sity Project are discussed. Two sets of parameters, corresponding to E=130(260) MeV for electron…

The Japan Proton Accelerator Research Complex (J-PARC) currently delivers a 1 MW, 3 GeV proton beam to the Materials and Life Science Experimental Facility (MLF). Power is expected to increase to 1.3 MW, driven by the needs of…

In this paper, a joint cross-layer design of adaptive modulation and coding (AMC) and cooperative automatic repeat request (C-ARQ) scheme is proposed for a secondary user in a shared-spectrum environment. First, based on the statistical…

The high-power RF systems for the Accelerator Production of Tritium (APT) program require high-power circulators at 350 MHz and 700 MHz to protect 1 MW Continuous Wave (CW) klystrons from reflected power. The 350 MHz circulator is based on…

We report the results of high gradient testing of two single cell off axis coupled standing wave accelerating structures. Two brazed standing wave side coupled structures with the same geometry were tested one made of pure copper Cu and one…

The ALICE experiment at CERN is preparing for a major upgrade for the third phase of data taking run (Run 3), when the high luminosity phase of the Large Hadron Collider (LHC) starts. The increase in the beam luminosity will result in high…

In view of a possible evolution of the CERN accelerator complex towards higher proton intensities, a 2.2 GeV H- linac with 4 MW beam power has been designed, for use in connection with an accumulator and compressor ring as proton driver of…

The upgrade of the normal conducting (NC) Radioactive Ion Beam EXperiment (REX)-ISOLDE heavy ion accelerator at CERN, under the High Intensity and Energy (HIE)-ISOLDE framework, proposes the use of superconducting (SC) quarter-wave…

The CLIC linear collider aims at accelerating multiple bunches of electrons and positrons and colliding them at a centre of mass energy of 3 TeV. These bunches will be accelerated through X-band linacs, operating at an accelerating…

Injected beam energy and energy spread are critical parameters affecting the performance of our rapid cycling synchrotron (RCS). A real-time energy monitoring system is being installed to examine the H- beam out of the Intense Pulsed…

Experimental results, supported by precise modelling, demonstrate optimisation of a plasma-based injector with intermediate laser pulse energy ($<1$ J), corresponding to a normalised vector potential $a_0 = 2.15$, using ionisation injection…

We report on suppression of long-range wakefields in CLIC accelerating structures. Strong detuning and moderate damping is employed. In these initial design studies we focus on the CLIC_G structure and enforce a moderate Q of 300 and 500.…

The High Energy Photon Source (HEPS), is the first fourth-generation storage ring light source being built in the suburb of Beijing, China. The storage ring was designed with the emittance lower than 60 pm.rad with a circumference of 1.36…