Related papers: A Physical-layer Rateless Code for Wireless Channe…
This paper studies Gaussian Two-Way Relay Channel where two communication nodes exchange messages with each other via a relay. It is assumed that all nodes operate in half duplex mode without any direct link between the communication nodes.…
Motivated by MIMO broad-band fading channel model, in this section a comparative study is presented regarding various uncoded adaptive and non-adaptive MIMO detection algorithms with respect to BER/PER performance, and hardware complexity.…
Wireless relay network is a solution to extend the reach of a wireless connection by installing a relay node between the source node and the sink node. Due to the broadcast nature of wireless transmission, the sink node has a chance to…
Slow fading broadcast channels can model a wide range of applications in wireless networks. Due to delay requirements and the unavailability of the channel state information at the transmitter (CSIT), these channels for many applications…
Designing channel codes under low-latency constraints is one of the most demanding requirements in 5G standards. However, a sharp characterization of the performance of traditional codes is available only in the large block-length limit.…
In this paper, we propose a fast decoder algorithm for uniquely decodable (errorless) code sets for overloaded synchronous optical code-division multiple-access (O-CDMA) systems. The proposed decoder is designed in a such a way that the…
In this letter, we analyze the achievable rate of ultra-reliable low-latency communications (URLLC) in a randomly modeled wireless network. We use two mathematical tools to properly characterize the considered system: i) stochastic geometry…
The high computational cost of approaching the performance of Maximum-likelihood (ML) decoding has limited its practical use for decades. Because the complexity grows exponentially with the message length, researchers have spent years…
Line codes make it possible to mitigate interference, to prevent short pulses, and to generate streams of bipolar signals with no direct-current (DC) power content through balancing. They find application in magnetic recording (MR) devices,…
Since the discovery of turbo codes 20 years ago and the subsequent re-discovery of low-density parity-check codes a few years later, the field of channel coding has experienced a number of major advances. Up until that time, code designers…
In this letter, we consider a Linear Quadratic Gaussian (LQG) control system where feedback occurs over a noiseless binary channel and derive lower bounds on the minimum communication cost (quantified via the channel bitrate) required to…
We consider the design of coding schemes for the wireless two-way relaying channel when there is no channel state information at the transmitter. In the spirit of the compute and forward paradigm, we present a multilevel coding scheme that…
This work considers the design of short non-binary low-density parity-check (LDPC) codes over finite fields of order m, for channels with phase noise. In particular, m-ary differential phase-shift keying (DPSK) modulated code symbols are…
Physical-layer network coding (PNC) is a communications paradigm that exploits overlapped transmissions to boost the throughput of wireless relay networks. A high point of PNC research was a theoretical proof that PNC that makes use of…
A new coded modulation scheme is proposed. At the transmitter, the concatenation of a distribution matcher and a systematic binary encoder performs probabilistic signal shaping and channel coding. At the receiver, the output of a bitwise…
We present an analysis, under iterative decoding, of coset LDPC codes over GF(q), designed for use over arbitrary discrete-memoryless channels (particularly nonbinary and asymmetric channels). We use a random-coset analysis to produce an…
In this paper, we address the design of high spectral-efficiency Barnes-Wall (BW) lattice codes which are amenable to low-complexity decoding in additive white Gaussian noise (AWGN) channels. We propose a new method of constructing complex…
Physical layer approaches for generating secret encryption keys for wireless systems using channel information have attracted increased interest from researchers in recent years. This paper presents a new approach for calculating…
In this work, we consider the task of target localization using quantized data in Wireless Sensor Networks (WSNs). We propose an energy efficient localization scheme by modeling it as an iterative classification problem. We design coding…
Physical-layer key generation methods utilize the variations of the communication channel to achieve a secure key agreement between two parties with no prior security association. Their secrecy rate (bit generation rate) depends heavily on…