Related papers: GPU Enhancement of the Trigger to Extend Physics R…
A major LHCb detector upgrade will be installed during long shutdown~4 (LS4) of the CERN Large Hadron Collider. The experiment will operate at a maximum luminosity of up to $1.5\times 10^{34}\mathrm{cm}^{-2}\mathrm{s}^{-1}$, with acceptance…
Production of neutrinos is abundant at LHC. Flavour composition and energy reach of the neutrino flux from proton-proton collisions depend on the pseudorapidity $\eta$. At large $\eta$, energies can exceed the TeV, with a sizeable…
Several compelling beyond the Standard Model scenarios predict signals that result in unconventional charged particle trajectories. Signatures for which unusual tracks are the most conspicuous feature pose significant challenges for…
Conventional searches for new phenomena at collider experiments tend to focus on prompt particles, produced at the interaction point and decaying rapidly. New physics models including long-lived particles that travel a substantial distance…
The LHCb detector at the LHC has shown a very successful initial operation and it is expected that the experiment will accumulate an integrated luminosity in proton-proton collisions of around 1 fb-1 in 2011. The data already collected are…
This paper describes the CMS trigger system and its performance during Run 1 of the LHC. The trigger system consists of two levels designed to select events of potential physics interest from a GHz (MHz) interaction rate of proton-proton…
With the High Luminosity LHC upgrades, incorporating tracking information into the CMS Level-1 trigger becomes necessary in order to maintain a manageable trigger rate and good trigger performance e.g. to retain thresholds for electroweak…
At high energy physics experiments, processing billions of records of structured numerical data from collider events to a few statistical summaries is a common task. The data processing is typically more complex than standard query…
In high energy physics (HEP) experiments, the reconstruction of charged particle trajectories is one of the most fundamental yet computationally expensive parts of event processing. At future hadron colliders such as the High-Luminosity…
The major challenge posed by the high instantaneous luminosity in the High Luminosity LHC (HL-LHC) motivates efficient and fast reconstruction of charged particle tracks in a high pile-up environment. While there have been efforts to use…
In the forthcoming years the LHC experiments are going to be upgraded to benefit from the substantial increase of the LHC instantaneous luminosity, which will lead to larger, denser events, and, consequently, greater complexity in…
Full detector simulation was among the largest CPU consumer in all CERN experiment software stacks for the first two runs of the Large Hadron Collider (LHC). In the early 2010's, the projections were that simulation demands would scale…
Next generation High-Energy Physics (HEP) experiments are presented with significant computational challenges, both in terms of data volume and processing power. Using compute accelerators, such as GPUs, is one of the promising ways to…
Many compelling beyond the Standard Model scenarios predict signals that result in unconventional charged particle trajectories. Signatures for which unusual tracks are the most conspicuous feature of the event pose significant challenges…
The High-Luminosity LHC will put significant demands on trigger systems. To control trigger thresholds, the CMS Collaboration is designing a novel Level-1 track trigger. The Outer Tracker will use modules with pairs of sensor layers to read…
The Large Hadron electron Collider (LHeC) is a proposed facility which will exploit the new world of energy and intensity offered by the LHC for electron-proton scattering, through the addition of a new electron accelerator. This…
The CMS-TOTEM Precision Proton Spectrometer (CT-PPS) is an approved project to add tracking and timing information at approximately $\pm$210~m from the interaction point around the CMS detector. It is designed to operate at high luminosity…
The Level-1 trigger of the CMS experiment at CERN has been designed to select proton-proton interactions whose final state includes signatures of new physics in the form of high transverse energy electrons, photons, jets, or high missing…
The Large Hadron Collider (LHC) at CERN will see an upgraded hardware configuration which will bring a new era of physics data taking and related computational challenges. To this end, it is necessary to exploit the ever increasing variety…
The ATLAS trigger has been used very successfully to collect collision data during 2009 and 2010 LHC running at centre of mass energies of 900 GeV, 2.36 TeV, and 7 TeV. This paper presents the ongoing work to commission the ATLAS trigger…