Related papers: Quantum Limits of Interferometer Topologies for Gr…
Extending the sensitivity of terrestrial gravitational-wave detectors below 20 Hz is a long-standing challenge, limited by ground motion and inertial sensing noise. In this letter, we demonstrate ultra-high-vacuum compatible inertial…
We present a new quantum control strategy for increasing the shot-noise-limited sensitivity of optical interferometers. The strategy utilizes active phase-insensitive quantum filtering of the signal inside the interferometer and does not…
The sensitivities of ground-based gravitational-wave (GW) detectors are limited by quantum shot noise at a few hundred Hertz and above. Nonetheless, one can use a quantum-correlation technique proposed by Martynov, et al. [Phys. Rev. A 95,…
Quantum vacuum fluctuations impose strict limits on precision displacement measurements, those of interferometric gravitational-wave detectors among them. Introducing squeezed states into an interferometer's readout port can improve the…
Quantum technologies with quantum correlated light require photodiodes with near-perfect `true' quantum efficiency, the definition of which adequately accounts for the photodiode dark noise. Future squeezed-light-enhanced gravitational wave…
We present the concept of a sensitive AND broadband resonant mass gravitational wave detector. A massive sphere is suspended inside a second hollow one. Short, high-finesse Fabry-Perot optical cavities read out the differential…
Significant progress has been made in recent years on the development of gravitational wave detectors. Sources such as coalescing compact binary systems, neutron stars in low-mass X-ray binaries, stellar collapses and pulsars are all…
Broadband suppression of quantum noise below the Standard Quantum Limit (SQL) becomes a top-priority problem for the future generation of large-scale terrestrial detectors of gravitational waves, as the interferometers of the Advanced LIGO…
We propose using qumodes, quantum bosonic modes, for detecting high-frequency gravitational waves via the inverse Gertsenshtein effect, where a gravitational wave resonantly converts into a single photon in a magnetized cavity. For an…
We have recently suggested a new approach and design of an ultra-sensitive gravity wave detector antenna based on superconductivity. The idea was described in a short paper [1]: http://iopscience.iop.org/1742-6596/507/4/042013, in entries…
To date, frequency-dependent squeezed light has been used to reduce quantum noise in interferometric gravitational wave detectors by 6.1 dB (a factor of two). Future upgrades and detectors aim to both reduce quantum noise by 10 dB (a factor…
After giving a brief introduction and presenting a complete classification of gravitational waves (GWs) according to their frequencies, we review and summarize the detection methods, the sensitivities, and the sources. We notice that…
In the last years quantum correlations received large attention as key ingredient in advanced quantum metrology protocols, in this letter we show that they provide even larger advantages when considering multiple-interferometer setups. In…
This chapter is concerned with the question: how do gravitational waves (GWs) interact with their detectors? It is intended to be a theory review of the fundamental concepts involved in interferometric and acoustic (Weber bar) GW antennas.…
We study the photon counting noise in optical interferometers used for gravitational wave detection. In order to reduce quantum noise a squeezed vacuum is injected into the usually unused input port. It is investigated under which…
We introduce a diagnostic -- the quantum noise fraction $\beta$ -- that determines the maximum sensitivity improvement achievable through quantum enhancement for any gravitational wave detector. Applied to the landscape of proposed…
The ultrahigh-frequency (above 10 kHz) gravitational waves (GW) window provides a unique opportunity to detect primordial GWs, free from astrophysical foregrounds that dominate lower frequencies. A stochastic GW background in this range is…
Results from two optical-fiber gravitational-wave interferometric detectors are reported. The detector design is very small, cheap and simple to build and operate. Using two detectors has permitted various tests of the design principles as…
Within this decade gravitational wave detection will open a new observational window on the Universe. Advanced ground based interferometers covering the kHz frequency range will be online by 2016, and it is foreseeable the announcement of a…
A new procedure of the linear position measurement which allows to obtain sensitivity better than the Standard Quantum Limit and close to the Energetic Quantum Limit is proposed and analyzed in details. Proposed method is based on the…