Related papers: In-plane optical spectroscopy study on FeSe epitax…
We perform an in-plane optical spectroscopy measurement on high quality FeSe single crystals grown by a vapor transport technique. Below the structural transition at $T_{\rm s}\sim$90 K, the reflectivity spectrum clearly shows a gradual…
The record of superconducting transition temperature(Tc) has long been 56K for the iron-based high temperature superconductors(Fe-HTS's). Recently, in single layer FeSe films grown on SrTiO3 substrate, signs for a new 65K Tc record are…
Ultrathin FeSe films grown on SrTiO$_{3}$ substrates are a recent milestone in atomic material engineering due to their important role in understanding unconventional superconductivity in Fe-based materials. Using femtosecond time- and…
Recently, the signs of both superconducting transition temperature (Tc) beyond 60 K and spin density wave (SDW) have been observed in FeSe thin film on SrTiO3 (STO) substrate, which suggests a strong interplay between superconductivity and…
We systematically studied in-plane optical conductivity of FeSe$_{1-x}$Te$_{x}$ thin films fabricated on CaF$_{2}$ substrates for $x$ = 0, 0.1, 0.2, and 0.4. This system shows a large enhancement of superconducting transition temperature…
We have investigated the correlation between structural and transport properties in sputtered $\beta$-FeSe films grown onto SrTiO$_3$ (100). The growth parameters, such as substrate temperature and thickness, have been varied in order to…
The layered nature and simple structure of FeSe reveal this iron-based superconductor as a unique building block for the design of artificial heterostructure materials. While superconductivity develops in ultrathin films of FeSe on SrTiO3…
The electronic structure of FeSe thin films grown on SrTiO3 substrate is studied by angle-resolved photoemission spectroscopy (ARPES). We reveal the existence of Dirac cone band dispersions in FeSe thin films thicker than 1 Unit Cell below…
Single-layer FeSe films grown on (001) SrTiO3 substrates have shown a significant increase in superconducting transition temperature compared to bulk FeSe. Several mechanisms have been proposed to explain such enhancement, including…
In this study, we fabricate 5-30-nm-thick films of FeSe/STO using pulsed laser deposition (PLD). The grown films exhibit superconductivity with an onset $T_{\mathrm{c}}$ that is much higher than that of bulk FeSe under ambient pressure. The…
The optical properties of LaNiO$_3$ thin films are investigated over a wide energy and temperature range. Thin films of varying thickness were epitaxially grown by pulsed laser deposition on LaAlO$_3$ and SrTiO$_3$ substrates. The optical…
In this study, we grow FeSe/SrTiO$_{3}$ with thicknesses of 4-19 nm using pulsed laser deposition and investigate their magneto-transport properties. The thinnest film (4 nm) exhibit negative Hall effect, indicating electron transfer into…
Epitaxial Fe(Se,Te) thin films were prepared by pulsed laser deposition on (La0.18Sr0.82)(Al0.59Ta0.41)O3 (LSAT), CaF2-buffered LSAT and bare CaF2 substrates, which exhibit an almost identical in-plane lattice parameter. The composition of…
Charge transfer and electron-phonon coupling (EPC) are proposed to be two important constituents associated with enhanced superconductivity in the single unit cell FeSe films on oxide surfaces. Using high-resolution electron energy loss…
We report on fully epitaxial FeSe0.5Te0.5 (FST) thin films with high-quality grown on CaF2 (00l) substrate at a low temperature of 300{\deg}C by pulsed laser deposition. The transport Jc of thin films is up to 1.36 MA/cm2 in self-field and…
Interface enhanced superconductivity at two dimensional limit has become one of most intriguing research directions in condensed matter physics. Here, we report the superconducting properties of ultra-thin FeSe films with the thickness of…
Bulk FeSe is superconducting with a critical temperature $T_c$ $\cong$ 8 K and SrTiO$_3$ is insulating in nature, yet high-temperature superconductivity has been reported at the interface between a single-layer FeSe and SrTiO$_3$. Angle…
Superconducting epitaxial FeSe0.5Te0.5 thin films were prepared on SrTiO3 (001) substrates by pulsed laser deposition. The high purity of the phase, the quality of the growth and the epitaxy were studied with different experimental…
We have studied the effect of tensile strain on the superconductivity in FeSe films. 50 nm, 100 nm, and 200 nm FeSe films were grown on MgO, SrTiO$_3$, and LaAlO$_3$ substrates by using a pulsed laser deposition technique. X-ray diffraction…
Understanding the superconductivity at the interface of FeSe/SrTiO3 is a problem of great contemporary interest due to the significant increase in critical temperature (Tc) compared to that of bulk FeSe, as well as the possibility of an…