Related papers: WatSen: Design and testing of a prototype mid-IR s…
MAAT is proposed as a visitor mirror-slicer optical system that will allow the OSIRIS spectrograph on the 10.4-m Gran telescopio CANARIAS (GTC) the capability to perform Integral Field Spectroscopy (IFS) over a seeing-limited FoV…
This paper presents a study conducted to allow urban farmers to remotely monitor their farm through the design and development of an Internet of Things-based (IoT) microfarm prototype which utilized wick system as planting method. The…
The Wilkinson Microwave Anisotropy Probe (WMAP) has mapped the full sky in five frequency bands between 23 and 94 GHz. The primary goal of the mission is to produce high-fidelity, all-sky, polarization-sensitive maps that can be used to…
Time-domain thermoreflectance (TDTR) is a powerful technique for characterizing the thermal properties of layered materials. However, its effectiveness at modulation frequencies below 0.1 MHz is hindered by pulse accumulation effects,…
In this paper, the design, realization, and demonstration of a broadband millimeter-wave imaging system based on the synthetic aperture radar technique (SAR) are discussed. The proposed system, operating within the frequency range of…
The experimental investigation of a broadband far-infrared meta-material absorber is described. The observed absorptance is $>\,0.95$ from ${\rm 1-20\,THz}$ (${\rm 300-15\,\mu m}$) over a temperature range spanning ${\rm 5-300\,K}$. The…
Mid-infrared absorption spectroscopy is a well-established technique for non-destructive quantitative molecular analysis. Waveguide-integrated sensors provide a particularly compact solution operating with reduced sample volumes while…
We report here an experimental setup to perform three-pulse pump-probe measurements over a wide wavelength and temperature range. By combining two pump pulses in the visible (650-900 nm) and mid-IR (5-20 $\mu$m) range, with a broadband…
We demonstrate metamaterial metal-based bolometers, which take advantage of resonant absorption in that a spectral and/or polarization filter can be built into the bolometer. Our proof-of-principle gold-nanostructure-based devices operate…
Development of novel radiation-absorbent materials and devices for millimetre and submillimetre astronomy instruments is a research area of high interest, and with substantial engineering challenges. Alongside low-profile structure and…
We present a concept for using a polarization sensitive multispectral lidar to map the seasonal distribution and exchange of volatiles among the reservoirs of the Martian surface and atmosphere. The LIDAR instrument will be a…
Waveguide-enhanced Raman spectroscopy (WERS) is a promising technique for sensitive and selective detection of chemicals in a compact chip-scale platform. Coupling light on and off the sensor chip with fibers however presents challenges…
We design and characterize phase-modulated, ultra-compact, silicon-based axilens devices that combine efficient point focusing and grating selectivity within scalable 4-level phase mask configurations. The proposed designs are polarization…
Measurements of a well-characterised standard sample can verify the performance of an instrument. Typically, small-angle neutron scattering instruments are used to investigate a wide range of samples and may often be used in a number of…
Two different silicate/water ice mixtures representing laboratory analogues of interstellar and circumstellar icy grains were produced in the laboratory. For the first time, optical constants, the real and imaginary parts of the complex…
We present results from the first on-sky demonstration of a prototype astronomical integrated photonic spectrograph (IPS) using the Anglo-Australian Telescope near-infrared imaging spectrometer (IRIS2) at Siding Spring Observatory to…
SuperSpec is an on-chip filter-bank spectrometer designed for wideband moderate-resolution spectroscopy at millimeter wavelengths, employing TiN kinetic inductance detectors. SuperSpec technology will enable large-format spectroscopic…
This paper presents a conceptual design for a spectrometer designed specifically for characterizing transiting exoplanets with space-borne infrared telescopes. The design adopting cross-dispersion is intended to be simple, compact, highly…
We design a spectrally resolved interferometer to measure the refractive index of transparent samples over a broad spectral range between 400 and 550 nm. The measuring device consists of a Michelson interferometer whose output is analysed…
Cost-efficient and easily integrable broadband mid-infrared (mid-IR) sources would significantly enhance the application space of photonic integrated circuits (PICs). Thermal incandescent sources are superior to other common mid-IR emitters…