Related papers: Simple feed-through for coupling optical fibres in…
We demonstrate an LED-based optical wireless link for fixed wireless access applications, at data rates of 1.5 Gbit/s over 50 m. Transmission between indoor equipment and outdoor access point is possible through metal-coated insulation…
We demonstrate the use of an anodic bonding technique for building a vacuum tight vapor cell for the use of Rydberg spectroscopy of alkali atoms with thin film electrodes on the inside of the cell. The cell is fabricated by simultaneous…
It is widely agreed that phase change materials (PCMs) are of high interest for sustainable energy future. Many of the applications require anti-leakage properties of PCM, that can be accomplished through PCM encapsulation. In this study,…
Optically trapped nanospheres in high-vaccum experience little friction and hence are promising for ultra-sensitive force detection. Here we demonstrate measurement times exceeding $10^5$ seconds and zeptonewton force sensitivity with…
A system for studying microcavity resonators at cryogenic temperatures (~10 K) through evanescent coupling via optical fiber taper waveguides is reported, and efficient fiber coupling to AlGaAs microdisk cavities with embedded quantum dots…
A normal metal - superconductor hybrid single-electron trap with tunable barrier is utilized as a tool for spectrum analysis at the extremely low signal levels, using only well filtered cryogenic microwave background as a photon source in…
We demonstrate the ability to load, cool and detect singly-charged calcium ions in a surface electrode trap using only visible and infrared lasers for the trapped-ion control. As opposed to the standard methods of cooling using…
Wiring systems powered by high-efficient superconductors have long been a dream of scientists, but researchers have faced practical challenges such as finding flexible materials. Here we report superconductivity in Nb2PdxS5-delta fibers…
A novel and simple approach to optical wavelength measurement is presented in this paper. The working principle is demonstrated using a tunable waveguide micro ring resonator and single photodiode. The initial calibration is done with a set…
The 3$\omega$ method is widely used to measure the thermal conductivity and the specific heat of wires and thin films. These measurements are typically performed under high vacuum conditions, which justify the use of heat transfer models…
At the ultra-thin limit below 20 nm, a film's electrical conductivity, thermal conductivity, or thermoelectricity depends heavily on its thickness. In most studies, each sample is fabricated one at a time, potentially leading to…
The low frequency vibrational spectra of hydrated porous silica are specifically sensitive to the hydrogen bond interactions and provides a wealth of information on the structural and dynamical properties of the water contained in the pores…
A series of experiments was performed to obtain permeability data on FiberForm(R), a commercial carbon preform used for manufacturing thermal protection systems. A porous sample was placed in a quartz flow-tube heated by an isothermal…
The EXperiment for Cryogenic Large-Aperture Intensity Mapping (EXCLAIM) is a balloon-borne telescope designed to survey star formation over cosmological time scales using intensity mapping in the 420 - 540 GHz frequency range. EXCLAIM uses…
A simple hole-type secondary scintillation structure (2 mm-hole, 5 mm-pitch, 5 mm-thickness) is introduced and its operation demonstrated in pure xenon in the pressure range 2-10 bar. The new device, characteristically translucent, has been…
We have produced high transmission sub-wavelength tapered optical fibers for the purpose of whispering gallery mode coupling in fused silica microcavities at 780 nm. A detailed analysis of the fiber transmittance evolution during tapering…
Integration of the next generation of photonic structures with electronic and optical on-chip components requires the development of effective methods for confining and controlling light in subwavelength volumes. Several techniques enabling…
Three different types of Er doped photosensitive fibers, germanium/erbium (Ge/Er) fiber, tin/germanium/erbium fiber (Sn/Er) and antimony/germanium/erbium fiber (Sb/Er) have been manufactured and studied for use in optical sensor systems.…
We demonstrate and characterize the transfer of a levitating silica nanosphere between two optical tweezers, at low pressure. Both optical traps are mounted on the heads of optical fibers and placed on translation stages in vacuum chambers.…
Wicking is a widely studied process in both natural and artificial systems. In many industrial applications, such as heat pipes, the wicking liquid evaporates to regulate temperature effectively. This study focuses on a simpler scenario…