Related papers: Floating Electrode Electrowetting on Hydrophobic D…
Electrowetting is a commonly used tool to manipulate sessile drops on hydrophobic surfaces. By applying an external voltage over a liquid and a dielectric-coated surface, one achieves a reduction of the macroscopic contact angles for…
Herein, we describe a novel device configuration for double-plate electrowetting-on-dielectric system with a floating top-electrode. As conventional double-plate EWOD device requires a grounded electrode on top-plate, it will cause…
Water drops sliding on hydrophobic surfaces spontaneously separate charges at their rear. It is unclear how this charge separation affects the contact angles of a sliding drop. We slide grounded and insulated drops on hydrophobic surfaces…
Low voltage electrowetting on dielectrics on substrates with thin layer of lubricating fluid to reduce contact angle hysteresis is reported here. On smooth and homogeneous solid surfaces, it is extremely difficult to reduce contact angle…
Electrowetting on dielectric is demonstrated with a thin spin-coated fluoropolymer over an aluminum electrode. Previous efforts to use thin spin-coated dielectric layers for electrowetting have shown limited success due to defects in the…
The phenomenon of electrowetting, i.e., the dependence of the macroscopic contact angle of a fluid on the electrostatic potential of the substrate, is analyzed in terms of the density functional theory of wetting. It is shown that…
This fluid dynamics video showcases how optically induced electrowetting can be used to manipulate liquid droplets in open space and particulate phases inside the droplet. A photoconductive layer is added to a conventional…
We derive a model for voltage-induced wetting, so-called electrowetting, from the principle of virtual displacement. Our model includes the possibility that charge is trapped in or on the wetted surface. Experimentally, we show reversible…
We demonstrate droplet manipulation using electric signals to induce the liquid to wet or dewet on a hydrophilic conductive substrate in the air without adding layers. In this phenomenon, the contact angle changes more than 15{\deg} or…
The inter-connection between the elasticity of a dielectric film and the wetting of a sessile drop on the same, under an applied electrical voltage, remains unaddressed. Here, we report the electrowetting-on-dielectric (EWOD) behaviour of…
Electric voltage applied in electrowetting can induce speading, sliding and even jumping of an individual droplet by changing the intrinsic balance of three-phase interfacial tensions, which has been widely used for droplet manipulating in…
We introduce a droplet-jumping phenomenon on a superhydrophobic surface driven by the resonant AC electrowetting. The resonant electrical actuation enables a droplet to accumulate sufficient surface energy for jumping, and superhydrophobic…
We report electrowetting on a semiconductor using of a mercury droplet resting on a silicon surface. The effect is demonstrated using commercial n-type and p-type single-crystal (100) silicon wafers of different doping levels. The…
Liquid transport in microchip-based systems is important in many areas such as Laboratory-on-a-chip, Microfluidics and Optofluidics. Actuation of liquids in such systems is usually achieved using either mechanical displacement11 or via…
Interfacial energy dissipation during stick-slip motion of a liquid drop on a non-conductive polymer substrate is shown to lead to an irreversible increase in electrical charge. This previously unobserved phenomenon occurs during surface…
Thin dielectric stacks comprising a main insulating layer and a hydrophobic top coating are commonly used in low voltage electrowetting systems. However, in most cases, thin dielectrics fail to endure persistent electrowetting testing at…
When two electrolyte-immersed electrodes have different temperatures, a voltage $\Delta \psi$ can be measured between them. This electrolyte Seebeck effect is usually explained by cations and anions flowing differently in thermal gradients.…
Recent experiments by Kavousanakis et al., Langmuir, 2018 [1], showed that reversible electrowetting on superhydrophobic surfaces can be achieved by using a thick solid dielectric layer (e.g. tens of micrometers). It has also been shown,…
Battery electrode surfaces are generally coated with electronically insulating solid films of thickness 1-50 nm. Both electrons and Li+ can move at the electrode-surface film interface in response to the voltage, which adds complexity to…
A droplet position sensing scheme for monitoring multiple droplets has been proposed, which gives a direct voltage output linearly proportional to droplet position in electrowetting-on-dielectric (EWOD) based devices. An extra dielectric…