Related papers: Channel Sounding Waveforms Design for Asynchronous…
This paper studies the coordinated beamforming design problem for the multiple-input single-output (MISO) interference channel, assuming only channel distribution information (CDI) at the transmitters. Under a given requirement on the rate…
In this paper, we study the channel estimation problem in correlated massive multiple-input-multiple-output (MIMO) systems with a reduced number of radio-frequency (RF) chains. Importantly, other than the knowledge of channel correlation…
This paper focuses on radar waveform optimization for minimizing the Cram\'er-Rao bound (CRB) in a multiple-input multiple-output (MIMO) radar system. In contrast to conventional approaches relying on semi-definite programming (SDP) and…
Fully digital massive MIMO systems with large numbers (1000+) of antennas offer dramatically increased capacity gains from spatial multiplexing and beamforming. Designing digital receivers that can scale to these array dimensions presents…
Hybrid analog and digital beamforming has emerged as a key enabling technology for millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) communication systems since it can balance the trade-off between system performance…
In this paper, we propose a beamforming design for dual-functional radar-communication (DFRC) systems at the millimeter wave (mmWave) band, where hybrid beamforming and sub-arrayed MIMO radar techniques are jointly exploited. We assume that…
Current multi-channel speech enhancement systems mainly adopt single-output architecture, which face significant challenges in preserving spatio-temporal signal integrity during multiple-input multiple-output (MIMO) processing. To address…
This paper presents a generalized closed-form beamforming technique that can achieve the maximum degrees of freedom in compounded multiple-input multiple-output (MIMO) broadcast channels with mixed classes of multiple-antenna users. The…
Cell-Free Massive Multiple-input Multiple-output (mMIMO) consists of many access points (APs) in a coverage area that jointly serve the users. These systems can significantly reduce the interference among the users compared to conventional…
In this paper, a joint design of instantaneous channel estimation, beam tracking, and adaptive beamformer construction for a massive multiple-input multiple-output (MIMO) system is proposed. This design focuses on efficiency in terms of…
In this letter, we focus on designing constant-modulus waveform with discrete phases for the multi-input multi-output (MIMO) radar, where the signal-to-interference-plus-noise ratio (SINR) is maximized in the presence of both the…
To meet the increasingly demanding quality-of-service requirements of the next-generation multi-carrier mobile networks, it is essential to design multi-functional signalling schemes facilitating efficient, flexible, and reliable…
In this letter, we consider the multiple-input multiple-output (MIMO) radar waveform design in the presence of signal-dependent clutters and additive white Gaussian noise. By imposing the constant modulus constraint (CMC) and waveform…
We demonstrate that separating beamforming (i.e., downlink precoding and uplink combining) and channel estimation in multi-user MIMO wireless systems incurs no loss of optimality under general conditions that apply to a wide variety of…
Massive multiple-input multiple-output (MIMO) promises significantly higher performance relative to conventional multiuser systems. However, the promised gains of massive MIMO systems rely heavily on the accuracy of the absolute front-end…
This paper presents a scalable beamforming design for maximizing the spectral efficiency (SE) of multi-reconfigurable intelligent surface (RIS)-aided communications through joint optimization of the precoder and RIS phase shifts in…
Spherical microphone arrays (SMAs) and spherical loudspeaker arrays (SLAs) facilitate the study of room acoustics due to the three-dimensional analysis they provide. More recently, systems that combine both arrays, referred to as…
This paper studies the detection performance of a multiple-input-multiple-output (MIMO) multifunction radio frequency (MFRF) system, which simultaneously supports radar, communication, and jamming. We show that the detection performance of…
For a multi-user multiple-input multiple-output (MU-MIMO) wireless communication system, imagining that the locations of the users are now fully controllable, what is the maximum sum-capacity, and what are the corresponding optimal user…
Motivated by massive deployment of low data rate Internet of things (IoT) and ehealth devices with requirement for highly reliable communications, this paper proposes receive beamforming techniques for the uplink of a single-input…