Related papers: Large critical current density improvement in Bi-2…
In high-quality c-axis-oriented MgB2 thin films, we observed high critical current densities (Jc) of 16 MA/cm^2 at 15 K under self fields comparable to those of cuprate high-temperature superconductors. The extrapolated value of Jc at 5 K…
Bulk MgB2 samples were prepared under different synthesis conditions and analyzed by scanning and transmission electron microscopy. The critical current densities were determined from the magnetization versus magnetic field curves of bulk…
MgB2/Fe tapes with 2.5-15 at.% ZrB2 additions were prepared through the in situ powder-in-tube method. Compared to the pure tape, a significant improvement in the in-field critical current density Jc was observed, most notably for 10 at.%…
The critical current density has been measured on single crystals of Ru substituted BaFe2As2 superconductor at several temperatures and in fields up to 16 T. The magnetisation versus field isotherms reveal the occurrence of a clear second…
The nano-SiC doped MgB2/Fe wires were fabricated using a powder-in-tube method and an in-situ reaction process. The depression of Tc with increasing SiC doping level remained rather small due to the counterbalanced effect of Si and C…
We investigate the influence of Pearl vortices in the vicinity of an edge-type Josephson junction for a superconducting thin-film loop in the form of an annulus, under uniform magnetic field. Specifically, we obtain the exact analytic…
We report DC isothermal magnetization, global critical current density (JC), Intra-grain critical current density (JCintra) and resistive upper critical field (Bc2) of polycrystalline Y1-xCaxBa2Cu3O7-{\delta} (YBCO); x = 0.00, 0.05, 0.10,…
We scrutinize the enhanced superconducting performance of melt quench Bismuth based Bi2Sr2CaCu2O8 (Bi-2212) superconductor. The superconducting properties of melt quenched Bi-2212 (Bi2212-MQ) sample are compared with non-melted Bi2212-NM…
The microstructures of MgB2 wires prepared by the powder-in-tube technique and subsequent hot isostatic pressing were investigated using transmission electron microscopy. Large amount of crystalline defects including small angle twisting,…
In the mixed state of type II superconductors, vortices penetrate the sample and form a correlated system due to the screening of supercurrents around them. Interestingly, we can study this correlated system as a function of density and…
Tremendous efforts towards improvement in the critical current density (Jc) of iron based superconductors (FeSCs), especially at relatively low temperatures and magnetic fields, have been made so far through different methods, resulting in…
The V-Ti alloys are promising materials as alternate to the commercial Nb-based superconductors for high current-high magnetic field applications. However, the critical current density (J_c) of these alloys are somewhat low due to their low…
In this paper we calculate the critical currents in thin superconducting strips with sharp right-angle turns, 180-degree turnarounds, and more complicated geometries, where all the line widths are much smaller than the Pearl length $\Lambda…
Superconducting joints are one of the key technologies to make Ba1-xKxFe2As2 (Ba-122) superconducting wires or tapes for high-field applications. Herein, superconducting joints were fabricated by a simple cold-pressing method, and the joint…
The anisotropy of the critical current density (Jc) and its influence on measurement of irreversibility field (Birr) has been investigated for high quality, in-situ MgB2 strands. Comparison of transport and magnetization measurements has…
The current distribution and the AC loss in a composite superconducting tape containing a layer from magnetic material is calculated and compared with experiments, showing a very good agreement. The situations of an alternating uniform…
The critical current density (Jc) of hot isostatic pressed (HIPed) MgB2 wires, measured by d.c. transport and magnetization, is compared with that of similar wires annealed at ambient pressure. The HIPed wires have a higher Jc than the…
By feeding current into the topmost $\mathrm{Cu_2O_4}$-layer of a mesa etched into the surface of a $\mathrm{Bi_2Sr_2CaCu_2O_{8+x}}$ (BSCCO) single crystal, we measured its superconducting critical value from a sharp upturn or break in…
Mono- and multifilamentary MgB2/Fe tapes and wires with high transport critical current densities have been prepared using the powder-in-tube (PIT) process. The fabrication details are described. The effect of powder grain sizes and…
The critical current of superconductors is commonly measured by testing unloaded wires under an external magnetic field. While stressed by intense Lorentz forces, the existing HTS/LTS superconductors are prone to a reduction in critical…