Related papers: CYCLOPS2: the fibre image slicer upgrade for the U…

We present the design of SCALES (Slicer Combined with Array of Lenslets for Exoplanet Spectroscopy) a new 2-5 micron coronagraphic integral field spectrograph under construction for Keck Observatory. SCALES enables low-resolution (R~50)…

The CRyogenic InfraRed Echelle Spectrograph (CRIRES) Upgrade project CRIRES$^{+}$ extended the capabilities of CRIRES. It transformed this VLT instrument into a cross-dispersed spectrograph to increase the wavelength range that is covered…

ATLAS is a general purpose experiment approved for the LHC collider at CERN. An important component of the detector is the central hadronic calorimeter; for its construction more than 600,000 Wave Length Shifting (WLS) fibres (corresponding…

SCUBA-2 is a 10000-bolometer submillimetre camera on the James Clerk Maxwell Telescope (JCMT). The instrument commissioning was completed in September 2011, and full science operations began in October 2011. To harness the full potential of…

We have performed simultaneous X-ray and optical spectroscopic observations of the Low Mass X-ray Binary Cygnus X-2. We have used a new data system attached to the Low Resolution Imaging Spectrograph instrument on Keck II to obtain spectra…

In fiber-based spectroscopy within telescopes, a prevailing limitation has been the necessity to align the fiber diameter with the telescope's seeing conditions, often characterized by the Full Width at Half Maximum of the point spread…

Binospec is a wide-field optical (360 to 1000 nm) spectrograph commissioned at the MMT 6.5m telescope in 2017. In direct imaging mode Binospec addresses twin 8$^\prime$ (wide) by 15$^\prime$ (slit length) fields of view. We describe an…

FIRST (Fibered Imager foR a Single Telescope instrument) is a post-AO instrument that enables high contrast imaging and spectroscopy at spatial scales below the diffraction limit. FIRST achieves sensitivity and accuracy by a unique…

The production of science-ready data from major solar telescopes requires expertise beyond that of the typical observer. This is a consequence of the increasing complexity of instruments and observing sequences, which require calibrations…

We are building an image slicer integral field unit (IFU) to go on the IMACS wide-field imaging spectrograph on the Magellan Baade Telescope at Las Campanas Observatory, the Reformatting Optically-Sensitive IMACS Enhancement IFU, or ROSIE…

Liger is a next-generation near-infrared imager and integral field spectrograph (IFS) for the W.M. Keck Observatory designed to take advantage of the Keck All-Sky Precision Adaptive Optics (KAPA) upgrade. Liger will operate at spectral…

There exists a fundamental tradeoff between spectral resolution and the efficiency or throughput for all optical spectrometers. The primary factors affecting the spectral resolution and throughput of an optical spectrometer are the size of…

(Abridged) In the first part of this thesis, a general methodology for applying image deconvolution to wide-field CCD imagery. Results show that wavelet-based deconvolution can increase limiting magnitude up to 0.6 mag and improve limiting…

We present 36 observations of 17 visual binaries of moderate separation (range from 0.15'' to 0.79'') made with the 50 cm Cassegrain telescope of the Jagiellonian University in Cracow. The speckle interferometry technique was combined with…

The hard X-ray instruments at the Linac Coherent Light Source are in the design phase for upgrades that will take full advantage of the high repetition rates that will become available with LCLS-II-HE. The current X-ray Correlation…

The Side-Coupled Linac (SCL) section of the FNAL linac accelerates the beam from 117 MeV to 401.5 MeV, operating at 22-24 mA beam current. Transverse focusing is performed by 32 quadrupoles, and the beam orbit is guided by 19 dipole…

We report on the design, development and commissioning of an Integral Field Unit (IFU) that has been built for the Echellette Spectrograph and Imager (ESI) at the W.M. Keck Observatory. This image slicer--based IFU, which was commissioned…

We present the design and testing of a prototype in-plane echelle spectrograph based on an actively controlled fibre-fed double-pass design. This system aims to be small and efficient with the minimum number of optical surfaces - currently…

We present a progress report on the design and construction of the Field-Imaging Far-Infrared Line Spectrometer (FIFI LS) for the SOFIA airborne observatory. The design of the instrument is driven by the goal of maximizing observing…

We report an optimal extraction methodology, for the reduction of multi-object fibre spectroscopy data, operating in the regime of tightly packed (and hence significantly overlapping) fibre profiles. The routine minimises crosstalk between…