Related papers: Random Matrix Models, Double-Time Painlev\'e Equat…

This paper studies simultaneous wireless information and power transfer (SWIPT) systems in two-way relaying (TWR) channels. Here, two source nodes receive information and energy simultaneously via power splitting (PS) from the signals sent…

In this paper, the rate-energy region is studied for the wireless sensor relay network (WSRN) with energy harvesting in the presence of a jammer. In the model, a source communicates to a destination equipped with a single antenna with…

The end-to-end learning of Simultaneous Wireless Information and Power Transfer (SWIPT) over a noisy channel is studied. Adopting a nonlinear model for the energy harvester (EH) at the receiver, a joint optimization of the transmitter and…

In this work, we investigate the performance of a dual-hop multiple relays system consisting of mixed Radio-Frequency (RF)/Free Space Optical (FSO) channels. The RF channels are subject to Rayleigh fading while the optical links experience…

Interference among concurrent transmissions in a wireless network is a key factor limiting the system performance. One way to alleviate this problem is to manage the radio resources in order to maximize either the average or the worst-case…

Direct transport processes play an important role in wireless communications where an ideal setup uses microwave fields to establish reliable communication channels between transmitter and receiver. But it is inherent to the problem that…

In [1], we introduced a new, matrix algebraic, performance analysis framework for wireless systems with fading channels based on the matrix exponential distribution. The main idea was to use the compact, powerful, and easy-to-use, matrix…

This paper focuses on modeling and analysis of the temporal performance variations experienced by a mobile user in a wireless network and its impact on system level design. We consider a simple stochastic geometry model: the infrastructure…

Hybrid Automatic ReQuest (HARQ) protocol enables reliable communications in wireless systems. Usually, several parallel streams are sent in successive timeslots following a time-sharing approach. Recently, multi-layer HARQ has been proposed…

In wireless communication systems, dual-polarized (DP) instead of single-polarized (SP) multiple-input multiple-output (MIMO) transmission is used to improve the spectral efficiency under certain conditions on the channel and the…

Monitoring Wireless Sensor Networks (WSNs) are composed of sensor nodes that report temperature, relative humidity, and other environmental parameters. The time between two successive measurements is a critical parameter to set during the…

This paper proposes a multistatic radar (MSR) system utilizing a distributed wireless synchronization protocol. The wireless synchronization protocol uses a two-tone waveform exchange for frequency synchronization and a bi-directional…

This paper studies performance of various types of relay nodes in a 5G wireless network: conventional amplify-forward repeaters, (semi-)smart/smart amplify-forward repeaters with different levels of side information, and…

Dual functional radar and communication (DFRC) systems are a viable approach to extend the services of future communication systems. Most studies designing DFRC systems assume that the target direction is known. In our paper, we address a…

The design of wireless communication receivers to enhance signal processing in complex and dynamic environments is going through a transformation by leveraging deep neural networks (DNNs). Traditional wireless receivers depend on…

An asymptotic technique is developed to find the Signal-to-Interference-plus-Noise-Ratio (SINR) and spectral efficiency of a link with N receiver antennas in wireless networks with non-homogeneous distributions of nodes. It is found that…

This paper presents two-hop relay gain-scheduling control in a Wireless Sensor Network to estimate a static target prior characterized by Gaussian probability distribution. The target is observed by a network of linear sensors, whose…

Cooperative beamforming in relay networks is considered, in which a source transmits to its destination with the help of a set of cooperating nodes. The source first transmits locally. The cooperating nodes that receive the source signal…

This two-part paper focuses on the system design and performance analysis for a point-to-point resonant beam communication (RBCom) system under both the quasi-static and mobile scenarios. Part I of this paper proposes a…

This paper studies the impact of probabilistic shaping on effective signal-to-noise ratios (SNRs) and achievable information rates (AIRs) in a back-to-back configuration and in unrepeated nonlinear fiber transmissions. For back-to-back,…