Related papers: Current distribution and transition width in super…
Eddy current separation (ECS) is a process used throughout the scrap recycling industry for separating nonferrous metals from nonmetallic fluff. To date, however, the physical theory of ECS has generally been limited to empirical…
Being able to characterise objects at low frequencies, but above the limiting frequency of the eddy current approximation of the Maxwell system, is important for improving current metal detection technologies. Importantly, the upper…
Electroplated Bismuth (Bi) is commonly used in Transition-Edge Sensors (TESs) for X-rays because of its high stopping power and low heat capacity. Electroplated Bi is usually grown on top of another metal that acts as seed layer, typically…
We have fabricated Transition Edge Sensors (TESs) whose thermal characteristics are completely characterised by few-mode ballistic phonon exchange with the heat bath. These TESs have extremely small amorphous SiNx support legs: 0.2 um…
Motivated by recent experimental data on thin film superconductors and oxide interfaces we propose a random-resistor network apt to describe the occurrence of a metal-superconductor transition in a two-dimensional electron system with…
We have designed 3D numerical simulations of a soft spheres model, with size polidispersity and in athermal conditions, to study the transient shear banding that occurs during yielding of jammed soft solids. We analyze the effects of…
We investigate the description of current transfer in polycrystalline superconductors by percolation theory and its limitations. Various computer models that have been proposed are reviewed and related to the experimental and theoretical…
Threshold switching (TS) is a phenomenon where non-permanent changes in electrical resistance of a two-terminal device can be controlled by modulating the voltage bias. TS based on silver (Ag) conductive filaments has been observed in many…
Minimization of ac losses is essential for economic operation of high-temperature superconductor (HTS) ac power cables. A favorable configuration for the phase conductor of such cables has two counter-wound layers of HTS tape-shaped wires…
Spin-polarized transport is investigated in normal metal-superconductor (NS) junctions as a function of interface transmissivity as well as temperature when the density of states of a superconductor is Zeeman-split in response to an…
We analyze the influence of the magnetic field generated by the supercurrents (self-field) on the current density distribution by numerical simulations. The thickness of the superconducting film determines the self-field and consequently…
We study the transmission of a disordered waveguide subjected to a finite bias field. The statisticaldistribution of transmission is analytically shown to take a universal form. It depends on a singleparameter, the system length expressed…
Low power consumption in both static and dynamic modes of operation is a key requirement in modern, highly scaled nanoelectronics. Tunneling field-effect transistors (TFETs) that exploit direct band-to-band tunneling of charges and exhibit…
We have measured the persistent current in individual normal metal rings over a wide range of magnetic fields. From this data, we extract the first six cumulants of the single-ring persistent current distribution. Our results are consistent…
High-temperature superconductors (high-Tc SCs) host a rich landscape of electronic phases encompassing the pseudogap, strange metal, superconducting, antiferromagnetic insulating, and Fermi-liquid regimes. The superconducting phase is…
We analyze the statistical distribution of switching durations in spin-transfer switching induced by current steps, and discuss biasing strategies to enhance the reproducibility of switching durations. We use a macrospin approximation and…
We report Small-Angle Neutron Scattering (SANS) measurements on the vortex lattice in a PbIn polycrystal in the presence of an applied current. Using the rocking curves as a probe of the distribution of current in the sample, we observe…
We have developed a model for experiments in which the bias current applied to a Josephson junction is slowly increased from zero until the junction switches from its superconducting zero-voltage state, and the bias value at which this…
We discuss intrinsic mechanisms of nonequilibrium excess noise in superconducting devices and transition edge sensors. In particular, we present an overview of fluctuation-driven contributions to the current noise in the vicinity of the…
We have succeeded in operating a transition-edge sensor (TES) spectrometer and evaluating its performance at the SPring-8 synchrotron X-ray light source. The TES spectrometer consists of a 240 pixel National Institute of Standards and…