Related papers: Performance Improvement by Changing Modulation Met…
Analog electrical elements such as mixers, filters, transfer oscillators, isolating buffers, dividers, and even transmission lines contribute technical noise and unwanted environmental coupling in time and frequency measurements. Software…
Multidimensional modulation was widely studied in the past decades due to the explosive development of modern wireless communication. Here, we propose a spirally reconfigurable slotted antenna inspired by the multidimensional modulation.…
This article investigates the basic design principles for a new Wireless Network Operating System (WNOS), a radically different approach to software-defined networking (SDN) for infrastructure-less wireless networks. Departing from…
Reconfigurable distributed antenna and reflecting surface (RDARS) is a promising architecture for future sixth-generation (6G) wireless networks. In particular, the dynamic working mode configuration for the RDARS-aided system brings an…
Opportunistic spectrum access is based on channel state information and can lead to important performance improvements for the underlying communication systems. On the other hand adaptive modulation is also based on channel state…
Software-Defined Radio (SDR) is widely used not only as a practical application but also as a fitting benchmark of high-performance signal processing. We report using the SDR benchmark -- specifically, FM Radio reception -- to evaluate the…
An optimization procedure for multi-transmitter (MISO) wireless power transfer (WPT) systems based on tight semidefinite relaxation (SDR) is presented. This method ensures physical realizability of MISO WPT systems designed via convex…
Initial access in millimeter-wave (mmW) wireless is critical toward successful realization of the fifth-generation (5G) wireless networks and beyond. Limited bandwidth in existing standards and use of phase-shifters in analog/hybrid…
Novel industrial wireless applications require wideband, real-time channel characterization due to complex multipath propagation. Rapid machine motion leads to fast time variance of the channel's reflective behavior, which must be captured…
Many components used in signal processing and communication applications, such as power amplifiers and analog-to-digital converters, are nonlinear and have a finite dynamic range. The nonlinearity associated with these devices distorts the…
Ultra-reliable Low-Latency Communication (URLLC) is a key feature of 5G systems. The quality of service (QoS) requirements imposed by URLLC are less than 10ms delay and less than $10^{-5}$ packet loss rate (PLR). To satisfy such strict…
The problem of secure communication in Amplify-and-Forward (AF) relay networks with multiple eavesdroppers is considered. Assuming that a receiver (destination or eavesdropper) can decode a message only if the received SNR is above a…
Accurate and fast packet delivery rate (PDR) estimation, used in evaluating wireless link quality, is a prerequisite to increase the performance of mobile, multi-hop and multi-rate wireless ad hoc networks. Unfortunately, contemporary PDR…
In this paper, an analysis is carried out for a method to mitigate the path loss through the dynamic spectrum access (DSA) method. The path loss is a major component which determines the QoS of a wireless link. Its effect is complemented by…
In this paper, a highly-efficient single-switch-regulated resonant wireless power receiver with hybrid modulation is proposed. To achieve both high efficiency and good output voltage regulation, phase shift and pulse width hybrid modulation…
Fifth generation new radio aims to facilitate new use cases in wireless communications. Some of these new use cases have highly de-manding latency requirements; many of the powerful forward error correction codes deployed in current…
Development of smart spectrum sensing techniques is the most important task in the design of a cognitive radio system which uses the available spectrum efficiently. The adaptive SNR estimation based energy detection technique has the dual…
In this paper, we design a deep learning-based convolutional autoencoder for channel coding and modulation. The objective is to develop an adaptive scheme capable of operating at various signal-to-noise ratios (SNR)s without the need for…
In this paper we present our approach regarding the implementation of new wireless radio receiver exploiting filterbank techniques, using a software-development driven approach. Since most of the common radio communications systems share a…
The increasing complexity of recent Wi-Fi amendments is making optimal Rate Adaptation (RA) a challenge. The use of classic algorithms or heuristic models to address RA is becoming unfeasible due to the large combination of configuration…