Related papers: Low complexity sum rate maximization for single an…
In this work, we derive a lower bound on the training-based achievable downlink (DL) sum rate (SR) of a multi-user multiple-input-single-output (MISO) system operating in frequency-division-duplex (FDD) mode. Assuming linear minimum mean…
This paper considers multiple-input multiple-output (MIMO) full-duplex (FD) two-way secrecy systems. Specifically, both multi-antenna FD legitimate nodes exchange their own confidential message in the presence of an eavesdropper. Taking…
Cell-free Massive MIMO (mMIMO) is envisaged to be a next-generation technology beyond 5G with its high spectral efficiency and superior spatial diversity as compared to that of conventional MIMO technology. The main principle is that many…
In this research paper approximate mean of signal-to-interference-plus-noise ratio (SINR) under imperfect channel state information (CSI) is computed and maximized for throughput enhancement of MIMO interference networks. Each transmitter…
The propagation loss of RF signals is a significant issue in simultaneous wireless information and power transfer (SWIPT) systems. Additionally, ensuring information security is crucial due to the broadcasting nature of wireless channels.…
Generalized spatial modulation-aided affine frequency division multiplexing (GSM-AFDM) is conceived for reliable multiple-input multiple-output (MIMO) communications over doubly selective channels. \textcolor{black}{We commence by proposing…
The potential of deploying large-scale antenna arrays in future wireless systems has stimulated extensive research on hybrid transceiver designs aiming to approximate the optimal fully-digital schemes with much reduced hardware cost and…
Future multi-input multi-output (MIMO) wireless communications systems will use beamforming as a first-step towards realizing the capacity requirements necessitated by the exponential increase in data demands. The focus of this work is on…
This paper addresses the challenge of large model (LM)-embedded wireless network for handling the trade-off problem of model accuracy and network latency. To guarantee a high-quality of users' service, the network latency should be…
Massive MIMO systems are typically designed assuming linear power amplifiers (PAs). However, PAs are most energy efficient close to saturation, where non-linear distortion arises. For conventional precoders, this distortion can coherently…
This letter proposes a multi-stream selection framework for \ac{CF-MIMO} networks. Partially coherent transmission has been considered by clustering \acp{AP} into phase-aligned clusters to address the challenges of phase misalignment and…
The problem of power allocation is studied for a multiple-input multiple-output (MIMO) decode-and-forward (DF) two-way relaying system consisting of two source nodes and one relay. It is shown that achieving maximum sum-rate in such a…
Massive MIMO is a variant of multiuser MIMO, where the number of antennas $M$ at the base-station is large, and generally much larger than the number of spatially multiplexed data streams to/from the users. It has been observed that in many…
In this paper we aim to solve the multiuser multi-input multi-output (MIMO) downlink beamforming problem where one multi-antenna base station broadcasts data to many users. Each user is assigned multiple data streams and has multiple…
Distributed intelligent reflecting surfaces (IRSs) deployed in multi-user wireless communication systems promise improved system performance. However, the signal-to-interference-plus-noise ratio (SINR) analysis and IRSs optimization in such…
Substreams refer to the streams of each user in a system. Substream weighting, where the weights determine the prioritization order, can be important in multiple-input multiple-output interference channels. In this letter, a distributed…
This paper proposes a tensor-based parametric modeling and estimation framework in multiple-input multiple-output (MIMO) systems assisted by intelligent reflecting surfaces (IRSs). We present two algorithms that exploit the tensor structure…
In millimeter wave (mmWave) massive MIMO systems, existing alternating minimization (AltMin) based hybrid digital-analog precoding algorithms can achieve near-optimal spectral efficiency (SE) of the fully-digital precoding. However, this…
Massive multiple-input multiple-output (MIMO) is a key technology for 5G wireless communications with a promise of significant capacity increase. The use of low-resolution data converters is crucial for massive MIMO to make the overall…
The fundamental problem of our interest here is soft-input soft-output multiple-input multiple-output (MIMO) detection. We propose a method, referred to as subspace marginalization with interference suppression (SUMIS), that yields…