Related papers: SQUIDs based set-up for probing current noise and …
We report noise measurements performed on a SQUID magnetometer implementing Grooved Dayem nanobridge of YBCO as weak-links. The SQUID shows magnetic flux noise as low as 10 $\mu \Phi_0$/Hz$^{0.5}$. The magnetometer is realized by coupling…
An ordinary superconducting quantum interference device (SQUID) contains two weak links connected in parallel. We model a multiple-wire SQUID (MW-SQUID), generalized in two ways. First, the number of weak links, which are provided by…
We present a study of the controllable nonlinear dynamics of a micromechanical beam coupled to a dc-SQUID (superconducting quantum interference device). The coupling between these systems places the modes of the beam in a highly nonlinear…
We study non-Gaussian out-of-equilibrium current fluctuations in a mesoscopic NSN circuit at the point of a superconducting phase transition. The setup consists of a voltage-biased thin film nanobridge superconductor (S) connected to two…
We propose a model for magnetic noise based on spin-flips (not electron-trapping) of paramagnetic dangling-bonds at the amorphous-semiconductor/oxide interface. A wide distribution of spin-flip times is derived from the single-phonon…
We study the mechanical fluctuations of a micrometer sized silicon cantilever subjected to a strong heat flow, thus having a highly non-uniform local temperature. In this non-equilibrium steady state, we show that fluctuations are…
In order to investigate the origin of the until now unaccounted excess noise and to minimize the uncontrollable phenomena at the transition in X-ray microcalorimeters we have developed superconducting transition-edge sensors into an…
Frequency tunable qubit plays a significant role for scalable superconducting quantum processors. The state-of-the-art room-temperature electronics for tuning qubit frequency suffers from unscalable limit, such as heating problem, linear…
For the generation of static magnetic fields solenoids are frequently used for the purpose of research and development of magnetic field sensors. When such a sensor is to be analyzed with regard to its inherent noise the influence of other…
We report the fabrication and characterization of superconducting quantum interference devices (SQUIDs) based on InAs nanowires and vanadium superconducting electrodes. These mesoscopic devices are found to be extremely robust against…
We study out-of-equilibrium transport in disordered superconductors close to the superconducting transition. We consider a thin film connected by resistive tunnel interfaces to thermal reservoirs having different chemical potentials and…
A numerical model based on a lumped circuit element approximation for a bi-superconducting quantum interference device (bi-SQUID) operating in the presence of an external magnetic field is presented in this paper. Included in the model is…
We report on the low-frequency current fluctuations and electronic noise in thin-films made of bismuth selenide topological insulators. The films were prepared via the graphene-like mechanical exfoliation and used as the current conducting…
Optics and more recently coherent matter waves enabled inertial sensors such as accelerometers and gyroscopes to reach high levels of resolution and sensitivity. As these technologies rest on physical phenomena that require particular…
We study the implementation of a correlation measurement technique for the characterization of squeezed light which is nearly free of electronic noise. With two different sources of squeezed light, we show that the sign of the covariance…
Detection of the quantum fluctuations by conventional methods meets certain obstacles, since it requires high frequency measurements. Moreover, quantum fluctuations are normally dominated by classical noise, and are usually further…
Low-frequency resistance fluctuations cause excess noise in biased resistors. The magnitude of these fluctuations varies significantly between different resistor types. In this work measurements of excess noise in precision thin film and…
We report an accurate measurement of the phase noise of a thermally limited electronic oscillator at 300 K. By thermally limited we mean that the white signal-to-noise ratio of the oscillator is at or near the level generated by the thermal…
We consider the current fluctuations in a mesoscopic circuit consisting of nodes connected by arbitrary connectors, in a setup with multiple normal or superconducting terminals. In the limit of weak superconducting proximity effect,…
We consider a three-terminal system with a chiral edge channel connecting the source and drain terminals. Charge can tunnel between the chiral edge and a third terminal. The third terminal is maintained at a different temperature and…