Related papers: Designing a High Efficiency Pulse Width Modulation…
Motivated by challenges to existing multiuser transmission methods in a low signal to noise ratio (SNR) regime, and emergence of massive numbers of low data rate ehealth and internet of things (IoT) devices, in this paper we show that it is…
Simultaneous wireless information and power transfer (SWIPT) has emerged as a viable technique to energize and connect low-power autonomous devices and enable future Internet of Things (IoT). A major challenge of SWIPT is the energy…
We demonstrate an optical data wavelength converter based on an electrically driven photonic molecule structure comprising two coupled active silicon microring resonators. The converter, supplied by a continuous-wave (CW) microwave drive…
This paper considers the problem of designing a multilevel pulse width modulated waveform (PWM) with a prescribed harmonic content. Multilevel PWM design plays a major role in many diverse engineering disciplines. In power electronics,…
The growing popularity of Machine-to-Machine (M2M) communications in cellular networks is driving the need to optimize networks based on the characteristics of M2M, which are significantly different from the requirements that current…
This paper presents an analytical design of an ultrasonic power transfer system based on piezoelectric micro-machined ultrasonic transducer (PMUT) for fully wireless brain implants in mice. The key steps like the material selection of each…
Talkative power conversion is a switching ripple communication technique that integrates data modulation into a switched-mode power electronics converter, enabling simultaneous information transmission and power conversion. Despite numerous…
A novel pinching antenna system (PASS) enabled wireless power transfer (WPT) framework is proposed, where energy harvesting receivers (EHRs) and information decoding receivers (IDRs) coexist. By activating pinching antennas (PAs) near both…
We present a controller for a power electronic system composed of a fuel cell (FC) connected to a boost converter which feeds a resistive load. The controller aims to regulate the output voltage of the converter regardless of the…
This paper details the implementation and experimental validation of a real-time control system for a three-phase induction motor using the Texas Instruments TMS320F28379D microcontroller. The system integrates pulse-width modulation (PWM)…
Low-frequency oscillations are an inherent phenomena in transmission networks and renewable energy plants should be configured to damp them. Commonly, a centralised controller is used in PV plants to coordinate PV generators via…
A highly integrated, high performance, and re-configurable device, which is designed for the Nitrogen-Vacancy center based quantum applications, is reported. The digital compartment of the device is fully implemented in a…
Nowadays, PWM excitation is one of the most common waveforms seen by magnetic components in power electronic converters. Core loss modelling approaches such as improved Generalized Steinmetz equation (iGSE) or the loss map based on…
An algorithm for simulation of switching converters is proposed in the paper. The algorithm is based on simulation of averaged circuit model applying "switching cell" concept, and construction of instantaneous values of the waveforms using…
Electrically tunable optical devices present diverse functionalities for manipulating electromagnetic waves by leveraging elements capable of reversibly switching between different optical states. This adaptability in adjusting their…
In quantum computing systems the quantum states of qubits can be modified among others by applying light pulses. In order to achieve low computing error rates these pulses have to be precisely shaped in magnitude and phase. In practical…
We survey the current state of phase change memory (PCM), a non-volatile solid-state memory technology built around the large electrical contrast between the highly-resistive amorphous and highly-conductive crystalline states in so-called…
In this paper, we propose a novel polarized six-dimensional movable antenna (P-6DMA) to enhance the performance of wireless communication cost-effectively. Specifically, the P-6DMA enables polarforming by adaptively tuning the antenna's…
Synchrophasor technology is an emerging and developing technology for monitoring and control of wide area measurement systems (WAMS). In an elementary WAMS, two identical phasors measured at two different locations have difference in the…
The purpose of this project was to design and implement a pipeline Analog-to-Digital Converter using 0.35um CMOS technology. Initial requirements of a 25-MHz conversion rate and 8-bits of resolution where the only given ones. Although…