Related papers: A data acquisition system for longitudinal beam pr…
A real-time beam profile monitoring system is proposed for GeV photon beams at the BM4 beamline of the Mikamine site, Research Center for Accelerator and Radioisotope Science (RARiS; previously known as ELPH) at Tohoku University. This…
In storage-ring-based light sources, harmonic cavities are commonly employed to lengthen the bunch, thereby mitigating collective effects and increasing beam lifetime. While this dual-RF configuration provides important benefits, it also…
We provide a comprehensive technical analysis of the data acquisition process with oscillating delay lines for Terahertz-time domain spectroscopy. The utilization of these rapid stages, particularly in high-repetition-rate systems, is known…
The 4 electrode signals of the beam position detector(BPM) of the STORAGE ring of HEFEI Light Source are directly connected to the domestic oscilloscope with 12bit resolution, 10Gsps sampling rate and 2GHz bandwidth. The acquisition program…
In this paper, to synchronize Ultra Wideband (UWB) systems in ad-hoc multi-user environments, we propose a new timing acquisition approach for achieving a good performance despite the difficulties to get there. Synchronization constraints…
In this paper, we evaluate the use of a trained Long Short-Term Memory (LSTM) network as a surrogate for a Euler-Bernoulli beam model, and then we describe and characterize an FPGA-based deployment of the model for use in real-time…
This paper discusses a fast algorithm for analyzing the phases of a multi-tone phase calibration signal. The multi-tone method is superior to its single-tone counterpart. The PCal signal is a wide-band frequency comb derived from an…
Real-time, bunch-by-bunch monitoring of transverse position, longitudinal phase, and bunch length is crucial for beam control in diffraction-limited storage rings, where complex collective dynamics pose unprecedented diagnostic challenges.…
The Intense Pulsed Neutron Source has been an operating user facility for more than 20 years. Development of an upgrade for the data acquisition system has been in progress for some time now. Now that the initial installation on the test…
Learning to control a safety-critical system with latent dynamics (e.g. for deep brain stimulation) requires taking calculated risks to gain information as efficiently as possible. To address this problem, we present a…
In synchrotron machines, the beam extraction is accomplished by a combination of septa and kicker magnets which deflect the beam from an accelerator into another. Ideally the kicker field must rise/fall in between the beam bunches. However,…
A collaboration between Fermilab and the Institute for High Energy Physics (IHEP), Beijing, has developed a beam position monitor for the IHEP test beam facility. This telescope is based on 5 stations of silicon strip detectors having a…
The intensity of charged particle beams at Fermilab must be kept within pre-determined safety and operational envelopes in part by assuring all beam within a few percent has been transported from any source to destination. Beam intensity…
A high peak current, flat longitudinal phase space electron beam is desirable for efficient x-ray free electron laser (FEL) radiation in next generation light sources. To attain such a beam requires the extensive design of the linear…
A dedicated 4{\pi}{\beta} (LS)-{\gamma} (HPGe)digital coincidence system has been developed in this work, which includes five acquisition channels. Three analog-to-digital converter (ADC) acquisition channels with an acquisition resolution…
In order to meet the needs of Fermilabs planned post-collider experimental program, the total proton throughput of the 8 GeV Booster accelerator must be nearly doubled within the next two years. A system of 48 ramped corrector magnets has…
The completion of the PIP-II project and its superconducting linear accelerator will provide up to 1.2 MW of beam power to the LBNF/DUNE facility for neutrino physics. It will also be able to produce high-power beams directly from the linac…
The Proton Improvement Plan, Stage Two (PIP-II) is a program of upgrades proposed for the Fermilab injection complex, which central part is an 800 MeV, 2 mA CW SRF linac. A prototype of the PIP-II linac front end called PIP-II Injector Test…
The POEMMA-Balloon with Radio (PBR) mission incorporates an advanced data processing system (DP) to enable the detection and characterization of ultra-high-energy cosmic rays and astrophysical neutrinos. The data acquisition (DAQ) system…
The Main Control Room of the Fermilab accelerator complex continuously gathers extensive time-series data from thousands of sensors monitoring the beam. However, unplanned events such as trips or voltage fluctuations often result in beam…