Related papers: High-frequency performance of scaled carbon nanotu…
A suspended carbon nanotube can act as a nanoscale resonator with remarkable electromechanical properties and the ability to detect adsorption on its surface at the level of single atoms. Understanding adsorption on nanotubes and other…
The attachment of semiconducting nanoparticles to carbon nanotubes is one of the most challenging subjects in nanotechnology. Successful high coverage attachment and control over the charge transfer mechanism and photo-current generation…
We present characterization of a lock-in amplifier based on a field programmable gate array capable of demodulation at up to 50 MHz. The system exhibits 90 nV/sqrt(Hz) of input noise at an optimum demodulation frequency of 500 kHz.The…
Owing to their long phonon mean free paths (MFPs) and high thermal conductivity, carbon nanotubes (CNTs) are ideal candidates for, e.g., removing heat from electronic devices. It is unknown, however, how the intrinsic phonon MFPs depend on…
We have generated and detected the radial-breathing mode of coherent lattice vibrations in single-walled carbon nanotubes using ultrashort laser pulses. Because the band gap is a function of diameter, these diameter oscillations cause…
High electric conductivity ~100 MegaSiemens/m and Seebeck coefficient >200 mkV/K of carbon nanotubes (CNT) make them attractive for a variety of applications. Unfortunately, a high thermal conductivity ~ 3000 W/(m*K) due to the phonon…
Hypersound Absorption of acoustic phonons having $ql>>1$ in a degenerate Carbon Nanotube (CNT) with linear energy dispersion near the Fermi level was theoretically studied. The general expression for the absorption coefficient ($\Gamma$)…
Full Adder is one of the critical parts of logical and arithmetic units. So, presenting a low power full adder cell reduces the power consumption of the entire circuit. Also, using Nano-scale transistors, because of their unique…
Wireless transfer of power via high frequency microwave radiation using a miniature split ring resonator rectenna is reported. RF power is converted into DC power by integrating a rectification circuit with the split ring resonator. The…
We have investigated electrical transport in a diffusive multiwalled carbon nanotube contacted using superconducting leads made of Al/Ti sandwich structure. We find proximity-induced superconductivity with measured critical currents up to…
Electron field emission characteristics of individual multiwalled carbon nanotubes have been investigated by a piezoelectric nanomanipulation system operating inside a scanning electron microscopy chamber. The experimental setup ensures a…
This paper discusses early results associated with a fully-digital direct-conversion array receiver at 28~GHz. The proposed receiver makes use of commercial off-the-shelf (COTS) electronics, including the receiver chain. The design consists…
We demonstrate a fully tunable diode structure utilizing a fully suspended single-walled carbon nanotube (SWNT). The diode's turn-on voltage under forward bias can be continuously tuned up to 4.3 V by controlling gate voltages, which is ~6…
The definition of the intrinsic cut-off frequency ($f_T$) based on the current gain equals to one (0 dB) is critically analyzed. A condition for the validity of the quasi-static estimation of $f_T$ is established in terms of the temporal…
We demonstrate the use of radio-frequency (rf) resonators to measure the capacitance of nano-scale semiconducting devices in field-effect transistor configurations. The rf resonator is attached to the gate or the lead of the device.…
We report on the fabrication and room temperature measurements of a high frequency electrical signal detector. The device is based on the ballistic transport in graphene to detect a high frequency signal. The observed response is linear in…
Nanoscale resonators that oscillate at high frequencies are useful in many measurement applications. We studied a high-quality mechanical resonator made from a suspended carbon nanotube driven into motion by applying a periodic radio…
The electronic and transport properties of (10, 0) single-walled carbon nanotube are studied by performing the first-principles calculations and semi-classical Boltzmann theory. It is found that the (10, 0) tube exhibits considerably large…
Generating non-reciprocal radio frequency transduction plays important roles in a wide range of research and applications, and an aspiration is to integrate this functionality into micro-circuit without introducing magnetic field, which,…
The bright exciton emission of semiconducting carbon nanotubes is appealing for optoelectronic and quantum photonic devices as well as fundamental studies of light-matter interaction in one-dimensional nanostructures. The photophysics of…