Related papers: High-frequency nanotube mechanical resonators
We have theoretically investigated the electromechanical properties of a freely suspended carbon nanotube that is connected to a constant-current source and subjected to an external magnetic field. We show that self-excitation of mechanical…
We demonstrate a new optomechanical device system which allows highly efficient transduction of femtogram nanobeam resonators. Doubly clamped nanomechanical resonators with mass as small as 25 fg are embedded in a high-finesse…
We demonstrate a high-Q ($>5 \times 10^{6}$) swept-frequency membrane mechanical resonator achieving octave resonance tuning via an integrated heater and an unprecedented acceleration noise floor below 1 $\mu$g Hz$^{-1/2}$ for frequencies…
The high-frequency transconductance and current noise of top-gated single carbon nanotube transistors have been measured and used to investigate hot electron effects in one-dimensional transistors. Results are in good agreement with a…
Fabrication of superconducting nanomechanical resonators for quantum research, detectors and devices traditionally relies on a lithographic process, resulting in oscillators with sharp edges and a suspended length limited to a few 100…
Superconducting resonators enable fast characterization and readout of mesoscopic quantum devices. Finding ways to perform measurements of interest on such devices using resonators only is therefore of great practical relevance. We report…
The measurement of micron-sized mechanical resonators by electrical techniques is difficult, because of the combination of a high frequency and a small mechanical displacement which together suppress the electromechanical coupling. The only…
We demonstrate strong coupling between the flexural vibration modes of a clamped-clamped micromechanical resonator vibrating at low amplitudes. This coupling enables the direct measurement of the frequency response via amplitude- and phase…
Magnetic nanoparticle based hyperthermia emerged as a potential tool for treating malignant tumours. The efficiency of the method relies on the knowledge of magnetic properties of the samples; in particular, knowledge of the frequency…
Low-frequency superconducting lumped-element resonators have recently attracted significant attention in the context of axion dark matter searches. Here we present the design and implementation of a fixed-frequency superconducting resonator…
We have fabricated suspended metal paddle resonators with carbon nanotubes functioning as self-detecting torsional springs. We observe gate-tunable resonances, that either tune to higher or to lower frequencies when increasing the dc…
The in-plane motion of an electron on helium can couple to superconducting microwave resonators via electrical dipole coupling, offering a robust and rapid readout scheme. In previous efforts, microwave resonator designs for electrons on…
Surface roughness influences significantly the quality factor of high frequency nanoresonators for large frequency - relaxation times within the non-Newtonian regime, where a purely elastic dynamics develops. It is shown that the influence…
The sensitivity of mechanical resonators to physical quantities such as acceleration, pressure, mass and temperature enables them to underpin sensing and metrology applications. Here, we observe that the resonance frequency of a…
The high frequency magnetic permeability of nanocomposite film consisting of the single-domain spherical ferromagnetic particles in the dielectric matrix is studied. The permeability is assumed to be determined by rotation of the…
We report our recent development in pursuing high Quality-Factor (high-Q factor) plasmonic resonances, with vertically aligned two dimensional (2-D) periodic nanorod arrays. The 2-D vertically aligned nano-antenna array can have high-Q…
Radio-frequency (RF) reflectometry is implemented in hybrid semiconductor-superconductor nanowire systems designed to probe Majorana zero modes. Two approaches are presented. In the first, hybrid nanowire-based devices are part of a…
We have constructed a noise measurement setup for high impedance carbon nanotube samples. Our setup, working in the frequency range of 600 - 900 MHz, takes advantage of the fact that the shot noise power is reasonably large for high…
Understanding and minimizing the sources of frequency noise in nanomechanical resonators is crucial for many sensing applications. In this work, we report an ultracoherent perimeter-mode nanomechanical resonator co-integrated with an…
We have designed and fabricated superconducting coplanar waveguide resonators with fundamental frequencies from 2 to $9 \rm{GHz}$ and loaded quality factors ranging from a few hundreds to a several hundred thousands reached at temperatures…