Related papers: Measurement-induced qubit state mixing in circuit …
Characterizing noise in superconducting qubits is essential for improving coherence and gate performance. Conventional noise-sensing methods typically use the qubit itself as the sensor, which limits both accessible bandwidth and…
The performance of a wide range of quantum computing algorithms and protocols depends critically on the fidelity and speed of the employed qubit readout. Examples include gate sequences benefiting from mid-circuit, real-time,…
We present a readout method for superconducting flux qubits. The qubit quantum flux state can be measured by determining the Josephson inductance of an inductively coupled DC superconducting quantum interference device (DC-SQUID). We…
A better understanding of the noise causing qubit decoherence is crucial for improving qubit performance. The noise spectrum affecting the qubit may be extracted by measuring dephasing under the application of pulse sequences but requires…
Millimeter waves are emerging as an enabling technology for connecting and enhancing different quantum platforms such as Rydberg atoms, optomechanics, and superconducting qubits. In this work, we focus on the interaction between millimeter…
The scalable application of quantum information science will stand on reproducible and controllable high-coherence quantum bits (qubits). Here, we revisit the design and fabrication of the superconducting flux qubit, achieving a planar…
Qubit measurement and control in circuit QED rely on microwave drives, with higher drive amplitudes ideally leading to faster processes. However, degradation in qubit coherence time and readout fidelity has been observed even under moderate…
Fast, high-fidelity, and low back-action readout plays a crucial role in the advancement of quantum error correction (QEC). Here, we demonstrate high-performance multiplexed readout of superconducting qubits using a tunable broadband…
We demonstrate the suppression of photon shot noise dephasing in a superconducting qubit by eliminating its dispersive coupling to the readout cavity. This is achieved in a tunable coupling qubit, where the qubit frequency and coupling rate…
We report on long-term measurements of a highly coherent, non-tunable superconducting transmon qubit, revealing low-frequency burst noise in coherence times and qubit transition frequency. We achieve this through a simultaneous measurement…
We present a new method to measure 1/f noise in Josephson quantum bits (qubits) that yields low-frequency spectra below 1Hz. Comparison of noise taken at positive and negative bias of a phase qubit shows the dominant noise source to be flux…
Fault-tolerant quantum information processing with flawed qubits and gates requires highly efficient, quantum non-demolition (QND) qubit readout. In superconducting circuits, qubit readout using coherent light with fidelity above 99% has…
In a qubit system, the measurement operator does not necessarily commute with the qubit Hamiltonian, so that the readout process demolishes (mixes) the qubit energy eigenstates. The readout time is therefore limited by such a mixing time…
The measurement of a quantum two-level system, or a qubit in modern terminology, often involves an electromagnetic field that interacts with the qubit, before the field is measured continuously and the qubit state is inferred from the noisy…
We study decoherence of the Josephson charge qubit by measuring energy relaxation and dephasing with help of the single-shot readout. We found that the dominant energy relaxation process is a spontaneous emission induced by quantum noise…
We investigate coupling an encoded spin qubit to a microwave resonator via qubit energy level curvature versus gate voltage. This approach enables quantum non-demolition readout with strength of tens to hundred MHz all while the qubit stays…
Many superconducting qubit systems use the dispersive interaction between the qubit and a coupled harmonic resonator to perform quantum state measurement. Previous works have found that such measurements can induce state transitions in the…
We examine the non-stationary evolution of a coupled qubit-transmission line-resonator system coupled to an external drive and the resonator environment. By solving the equation for a non-stationary resonator field, we determined the…
While relatively easy to engineer, static transverse coupling between a qubit and a cavity mode satisfies the criteria for a quantum non-demolition (QND) measurement only if the coupling between the qubit and cavity is much less than their…
We implemented experimentally an interferometer-type charge qubit consisting of a single-Cooper-pair transistor closed by a superconducting loop that is in flip-chip configuration inductively coupled to a radio frequency tank circuit. The…