Related papers: Maximal air bubble entrainment at liquid drop impa…
The non-linear interaction between air and a water droplet just prior to high-speed impingement on a surface is a phenomenon that has been researched extensively and occurs in a number of industrial settings. The role that surface…
When do droplets merge and when do they bounce? Over the last 10 years, advances in experimental techniques, such as high-speed cameras, have enabled us to make important discoveries on how the dynamics of thin gas films can influence the…
Intuitively, slow droplets stick to a surface and faster droplets splash or bounce. However, recent work suggests that on non-wetting surfaces, whether microdroplets stick or bounce depends only on their size and fluid properties, but not…
Rain drops form in clouds by collision of submillimetric droplets falling under gravity: larger drops fall faster than smaller ones and collect them on their path. The puzzling stability of fogs and non-precipitating warm clouds with…
A conceptual model relating the whitecap coverage to the bubble plume buoyancy is developed following the observation that the entrained bubble plume buoyancy constitutes a large portion of the breaking wave energy dissipation. The…
The inherent instability of oscillatory flows presents a significant challenge in microfluidics, impairing performance in different applications from particle detachemnt to organs-on-a-chip. Trapped air inside a microfluidic system…
The macroscopic dynamics of a droplet impacting a solid is crucially determined by the intricate air dynamics occurring at the vanishingly small length scale between droplet and substrate prior to direct contact. Here we investigate the…
Bubbles at a free surface surface usually burst in ejecting myriads of droplets. Focusing on the bubble bursting jet, prelude for these aerosols, we propose a simple scaling for the jet velocity and we unravel experimentally the intricate…
We report a new type of drop instability, where the density difference between the drop and the solvent is negative. We show that the drop falls inside the solvent down to a minimum height, then fragmentation takes place and secondary…
Soft surfaces impacted by liquid droplets trap more air underneath than their rigid counterpart. The extended lifetime of the air film not only facilitates bouncing behaviours of the impacting droplets but also increases the possibility of…
We investigate the phenomenon of air entrainment in turbulent water jets exiting a pool near the free surface. Our experimental results reveal that bubble entrainment occurs only within a specific region close to the point where the jet…
We present accurate measurements of the relative motion and deformation of two large bubbles released consecutively in a quiescent liquid confined in a thin-gap cell. Though the second bubble injected is smaller, we observed that in all…
We present the light-induced manipulation of absorbing liquid droplets in air. Ink droplets from a printer cartridge are used to demonstrate that absorbing liquids - just like their solid counterparts - can interact with regions of high…
The idea of contact angle was generalized by using the principle of minimum total energy. The problems of the shape of the two-dimensional sessile drop and the drop on an inclined surface are considered. The differential equations…
The impact of droplets on an inclined falling liquid film is studied experimentally using high-speed imaging. The falling film is created on a flat substrate with controllable thicknesses and flow rates. Droplets with different sizes and…
Motivated by recent experiments, we consider theoretically the compression of droplets pinned at the bottom on a surface of finite area. We show that if the droplet is sufficiently compressed at the top by a surface, it will always develop…
Droplet velocities used in impact studies were investigated using high-speed photography. It was determined that droplets do not reach terminal velocity before a typical impact, raising the question of how to predict impact velocity. This…
Hard particle erosion and cavitation damage are two main wear problems that can affect the internal components of hydraulic machinery such as hydraulic turbines or pumps. If both problems synergistically act together, the damage can be more…
A fiber withdrawn from a bath of a dilute particulate suspension exhibits different coating regimes depending on the physical properties of the fluid, the withdrawal speed, the particle sizes, and the radius of the fiber. Our experiments…
Injecting a non-dissolvable gas into a saturated liquid results in sub-cooling of the liquid due to forced evaporation into the bubble. Previous studies assumed the rate of evaporation of liquid into the bubble to be independent of the…