Related papers: A photonic crystal cavity-optical fiber tip nanopa…
Nanoscale photonic crystal cavity optomechanical devices enable detection of nanomechanical phenomena with a sensitivity sufficient to observe quantum effects. Here we present the design of a one-dimensional air-mode photonic crystal cavity…
A nanoparticle detection scheme with single particle resolution is presented. The sensor contains only a taper fiber thus offering the advantages of compactness and installation flexibility. Sensing method is based on monitoring the…
This paper reports on the excitation of surface plasmons on gold-coated nanofibre tips by side-illumination with a laser beam and the coupling of the surface plasmons to the optical fiber. The measurements show a strong dependence of the…
We demonstrate a simple and rapid epoxy-based method for transferring photonic crystal cavities to the facets of optical fibers. Passive Si cavities were measured via fiber taper coupling as well as direct transmission from the fiber facet.…
Quantum control of levitated dielectric particles is an emerging subject in quantum optomechanics. A major challenge is to efficiently measure and manipulate the particle's motion at the Heisenberg uncertainty limit. Here we present a…
Integrating fluorescent nanoparticles with high-Q, small mode volume cavities is indispensable for nanophotonics and quantum technologies. To date, nanoparticles have largely been coupled to evanescent fields of cavity modes, which limits…
We experimentally realized an optical nanofiber-based cavity by combining a 1-D photonic crystal and Bragg grating structures. The cavity morphology comprises a periodic, triplex air-cube introduced at the waist of the nanofiber. The cavity…
In situ measurement of analytes for in vivo or in vitro systems has been challenging due to the bulky size of traditional analytical instruments. Also, frequent in vitro concentration measurements rely on fluorescence-based methods or…
We demonstrate a nanotip electron source based on a graded index multimode silica optical fiber, tapered at one end to a radius of curvature r ~ 50 nm and coated with a thin film of gold. We report observation of laser-induced electron…
We describe the design, fabrication, and measurement of a cavity opto-mechanical system consisting of two nanobeams of silicon nitride in the near-field of each other, forming a so-called "zipper" cavity. A photonic crystal patterning is…
Optical trapping has proven to be a valuable experimental technique for precisely controlling small dielectric objects. However, due to their very nature, conventional optical traps are diffraction limited and require high intensities to…
The use of tapered optical fibers, i.e., optical nanofibers, for spectroscopy and the detection of small numbers of particles, such as neutral atoms or molecules, has been gaining ground in recent years. In this review, we briefly introduce…
We propose a method of trapping atoms in arrays near to the surface of a composite nanophotonic device with optimal coupling to a single cavity mode. The device, comprised of a nanofiber mounted on a grating, allows the formation of…
Over the preceding years, nickel (Ni) and its compounds have been increasingly employed in various aspects of human social life, metallurgical/industrial manufactures, healthcare, and chemical processes. Although Ni is considered an…
Optical detection of structures with dimensions smaller than an optical wavelength requires devices that work on scales beyond the diffraction limit. Here we present the possibility of using a tapered optical nanofiber as a detector to…
We present a method to realize active optical tips for use in near-field optics that can operate at room temperature. A metal-coated optical tip is covered with a thin polymer layer stained with CdSe nanocrystals or nanorods at low density.…
Photonic crystal nanocavities are used to enhance photoluminescence from single-walled carbon nanotubes. Micelle-encapsulated nanotubes are deposited on nanocavities within Si photonic crystal slabs and confocal microscopy is used to…
We discuss experimental studies of the interaction between a nanoscopic object and a photonic crystal membrane resonator of quality factor Q=55000. By controlled actuation of a glass fiber tip in the near-field of a photonic crystal, we…
Fiber-coupled sensors are well suited for sensing and microscopy in hard-to-reach environments such as biological or cryogenic systems. We demonstrate fiber-based magnetic imaging based on nitrogen-vacancy (NV) sensor spins at the tip of a…
Optical-based nanothermometry represents a transformative approach for precise temperature measurements at the nanoscale, which finds versatile applications across biology, medicine, and electronics. The assembly of ratiometric fluorescent…