Related papers: A 100 mA Low Voltage Linear Regulators for Systems…
The radiation hardness of passive CMOS pixel sensors fabricated in 150 nm LFoundry technology is investigated. CMOS process lines are especially of interest for large-scale silicon detectors as they offer high production throughput at…
Two, lightweight diode laser frequency stabilization systems designed for experiments in the field are described. A significant reduction in size and weight in both models supports the further miniaturization of measurement devices in the…
This letter presents a technique that enables very fine tunability of the frequency of Ring Oscillators (ROs). Multiple ROs with different numbers of tunable elements were designed and fabricated in a 65nm CMOS technology. A tunable element…
The introduction of smart electricity meters with cellular radio interface puts an additional load on the wireless cellular networks. Currently, these meters are designed for low duty cycle billing and occasional system check, which…
This paper presents a tunable liquid lens (TLL)-assisted indoor mobile visible light communication system. To mitigate performance degradation caused by user mobility and random receiver orientation, an electrowetting cuboid TLL is used at…
A line driver with configurable pre-emphasis is implemented in a 65 nm CMOS process. The driver utilizes a three-tap feed-forward equalization (FFE) architecture. The relative delays between the taps are selectable in increments of 1/16th…
This paper summarizes our work on experimental characterization and analysis of reduced-voltage operation in modern DRAM chips, which was published in SIGMETRICS 2017, and examines the work's significance and future potential. We take a…
This paper studies an architecture with digitally controllable gain and power consumption to mitigate the impact of process variations on CMOS low-noise amplifiers (LNAs). A \SI{130}{nm}, \SI{1.2}{V} LNA implementing the proposed…
Low Level RF (LLRF) control systems of linear accelerators (LINACs) are typically implemented with heterodyne based architectures, which have complex analog RF mixers for up and down conversion. The Gen 3 Radio Frequency System-on-Chip…
Line-of-sight (LoS) multi-input multi-output (MIMO) systems exhibit attractive scaling properties with increase in carrier frequency: for a fixed form factor and range, the spatial degrees of freedom increase quadratically for 2D arrays, in…
In this paper, we design a dimming compatible visible light communication (VLC) system in a standard office room according to illumination standards under channel constraints. We use overlapping pulse position modulation (OPPM) to support…
The market projection for Internet of Things (IoT) systems is appealing for the Power Line Communication (PLC) technology. A massive growth and a pervasive presence of these IoT objects is expected in our everyday life. About 20 billion of…
A deep learning (DL)-based power control algorithm that solves the max-min user fairness problem in a cell-free massive multiple-input multiple-output (MIMO) system is proposed. Max-min rate optimization problem in a cell-free massive MIMO…
In this paper a CMOS operational amplifier is presented which operates at 2V power supply and 1microA input bias current at 0.8 micron technology using non conventional mode of operation of MOS transistors and whose input is depended on…
This paper investigates the identification of observable low-frequency (LF) parameters of battery cell's equivalent circuit models (ECMs) using time-domain voltage and current measurements sampled at low frequency by built-in battery…
Silicon pixel sensors manufactured using commercial CMOS processes are promising instruments for high-energy particle physics experiments due to their high yield and proven radiation hardness. As one of the essential factors for the…
We consider Internet of Things (IoT) organized on the principles of cell-free massive MIMO. Since the number of things is very large, orthogonal pilots cannot be assigned to all of them even if the things are stationary. This results in an…
A clock synchronizing circuit for repeaterless low swing interconnects is presented in this paper. The circuit uses a delay locked loop (DLL) to generate multiple phases of the clock, of which the one closest to the center of the eye is…
High amplitude impulsive noise (IN) occurrence over power line channels severely degrades the performance of Orthogonal Frequency Division Multiplexing (OFDM)systems. One of the simplest methods to reduce IN is to precede the OFDM…
A new design for an open-hardware Digital-to-Analog Converter System-on-Module is presented for low-noise ion-trap electrode control. The design specifications were established to fill the technical needs of a modular, scalable DC electrode…