Related papers: Bulk Nanocrystalline Thermoelectrics Based on Bi-S…
Thermoelectric (TE) materials can directly convert heat into electrical energy. However, they sustain costly production procedures and batch-to-batch performance variations. Therefore, developing scalable synthetic techniques for…
Topological insulators are novel quantum materials with metallic surface transport, but insulating bulk behavior. Often, topological insulators are dominated by bulk contributions due to defect induced bulk carriers, making it difficult to…
A nanometric Sb2Te3 rhombohedral phase was produced from Sb and Te by mechanical alloying for 3 hours and its structural stability was studied by synchrotron X-ray diffraction (XRD) and Raman spectroscopy (RS) measurements as a function of…
It is now well established, both theoretically and experimentally, that very small changes in the size of isolated nanograins lead to substantial nonmonotonic variations, and sometimes enhancement, of the mean-field spectroscopic gap of…
Thermoelectric (TE) technology enables direct heat-to-electricity conversion and is gaining attention as a clean, fuel-saving, and carbon-neutral solution for industrial, automotive, and marine applications. Despite nearly a century of…
Thermoelectric materials allow the direct conversion of waste heat into electricity, and novel materials are being investigated for this purpose. Recently, doped Bi$_2$O$_2$Se has shown high application potential. In this study, we discuss…
Thermoelectric (Bi1-x Sbx)2Te3 (BST-x) compounds with x=0.2, 0.7 and 0.9 have been studied using synchrotron angle-dispersive powder x-ray diffraction in a diamond anvil cell up to 25 GPa (at room temperature). The results clearly indicate…
Thermoelectricity refers to the conversion of thermal energy into electrical energy and vice-versa, which relies on three main effects: Seebeck, Peltier and Thomson, all of which are manifestations of heat and electricity flow. In this work…
Layered chalcogenides including Bi2Te3, Sb2Te3, Bi-Sb-Te ternary alloys and heterostructures are known as great thermoelectric, topological insulators and recently highlighted as plasmonic building blocks beyond noble metals. Here, we…
The average and local structures of the (PbTe)1-x(PbS)x system of thermoelectric materials has been studied using the Rietveld and atomic pair distribution function (PDF) methods. Samples with 0:25 < x are macroscopically phase separated.…
The efficiency of energy conversion in thermoelectric generators (TEGs) is directly proportional to electrical conductivity and Seebeck coefficient while inversely to thermal conductivity. The challenge is to optimize these interdependent…
We report a novel synthesis for near monodisperse, sub-10-nm Bi2Te3 nanoparticles. At first, a new reduction route to bismuth nanoparticles is described which are applied as starting materials in the formation of rhombohedral Bi2Te3…
Embedding nanostructures within a bulk matrix is an important practical approach towards the electronic engineering of high performance thermoelectric systems. For power generation applications, it ideally combines the efficiency benefit…
Nd2Fe14B magnetic nanoparticles have been successfully produced using a surfactant-assisted ball milling technique. The nanoparticles with different size about 6, 20 and 300 nm were obtained by a size-selection process. Spin-reorientation…
There is evidence that magnetism can potentially increase the thermopower of materials, most likely due to magnon scattering, suggesting the incorporation of intrinsic magnetic semiconductors in non-magnetic thermoelectric materials. Here,…
As a result of suppressed phonon conduction, large improvements of the thermoelectric figure of merit, ZT, have been recently reported for nanostructures compared to the raw materials' ZT values. It has also been suggested that low…
Polycrystalline Sb 2 Te 3-x Se x (0.0 < x < 1.0) samples were synthesized by the solid state reaction method. The structural analysis showed that up to the maximal concentration of Se, the samples possess the Rhombohedral crystal symmetry…
In this work we present a detailed study and derivation of the thermopower and thermoelectric coefficient of nano-granular metals at large tunneling conductance between the grains, g_T>> 1. An important criterion for the performance of a…
Recent theoretical calculations and photoemission spectroscopy measurements on the bulk Bi2Se3 material show that it is a three-dimensional topological insulator possessing conductive surface states with nondegenerate spins, attractive for…
N-type Bi100-xSbx alloys have the highest thermoelectric figure of merit (zT) of all materials below 200K; here we investigate how filling multiple valence band pockets at T and H-points of the Brillouin zone produces high zT in p-type…