Related papers: Monobit Digital Receivers for QPSK: Design, Analys…
We study collaborative machine learning systems where a massive dataset is distributed across independent workers which compute their local gradient estimates based on their own datasets. Workers send their estimates through a multipath…
The fundamental limits of communication over multiple-input multiple-output (MIMO) networks are considered when a limited number of one-bit analog to digital converters (ADC) are used at the receiver terminals. Prior works have mainly…
For 5G it will be important to leverage the available millimeter wave spectrum. To achieve an approximately omni- directional coverage with a similar effective antenna aperture compared to state of the art cellular systems, an antenna array…
Modern communication receiver architectures center around digital signal processing (DSP), with the bulk of the receiver processing being performed on digital signals obtained after analog-to-digital conversion (ADC). In this paper, we…
In-phase/quadrature-phase (I/Q) imbalance is one of the most important hardware impairments in communication systems. It arises in the analogue parts of direct conversion radio frequency (RF) transceivers and can cause severe performance…
The use of 1-bit analog-to-digital converters (ADCs) is seen as a promising approach to significantly reduce the power consumption and hardware cost of multiple-input multiple-output (MIMO) receivers. However, the nonlinear distortion due…
We consider general multi-antenna fading channels with coarsely quantized outputs, where the channel is unknown to the transmitter and receiver. This analysis is of interest in the context of sensor network communication where low power and…
For 5G it will be important to leverage the available millimeter wave spectrum. To achieve an approximately omni- directional coverage with a similar effective antenna aperture compared to state of the art cellular systems, an antenna array…
The design of the analog demodulator for receivers with low-resolution analog-to-digital converters (ADC) is investigated. For infinite ADC resolution, demodulation to baseband with M = 2 orthogonal sinusoidal functions (quadrature…
We investigate massive multiple-input-multiple output (MIMO) uplink systems with 1-bit analog-to-digital converters (ADCs) on each receiver antenna. Receivers that rely on 1-bit ADC do not need energy-consuming interfaces such as automatic…
We aim at investigating the impact of low resolution digital-to-analog converters (DACs) at the transmitter and low resolution analog-to-digital converters (ADCs) at the receiver on the required bandwidth and the required signalto- noise…
This paper investigates a hardware-efficient massive multiple-input multiple-output integrated sensing and communication (MIMO-ISAC) system with 1-bit analog-to-digital converters (ADCs)/digital-to-analog converters (DACs). The proposed…
High data rates require vast bandwidths, that can be found in the sub-THz band, and high sampling frequencies, which are predicted to lead to a problematically high analog-to-digital converter (ADC) power consumption. It was proposed to use…
Low-resolution analog-to-digital converters (ADCs) are promising for reducing energy consumption and costs of multiuser multiple-input multiple-output (MIMO) systems with many antennas. We propose low-resolution multiuser MIMO receivers…
Affine frequency division multiplexing (AFDM) is a promising waveform for future wireless communication systems. In this paper, we analyze the impact of receiver in-phase and quadrature (IQ) imbalance and residual carrier frequency offset…
Large-scale multiple-antenna systems have been identified as a promising technology for the next generation of wireless systems. However, by scaling up the number of receive antennas the energy consumption will also increase. One possible…
Today's communication systems typically use high resolution analog-to-digital converters (ADCs). However, considering future communication systems with data rates in the order of 100Gbit/s the ADC power consumption becomes a major factor…
Differential space time block coding (STBC) achieves full spatial diversity and avoids channel estimation overhead. Over highly frequency-selective channels, STBC is integrated with orthogonal frequency division multiplexing (OFDM) to…
Hybrid analog/digital architectures and receivers with low-resolution analog-to-digital converters (ADCs) are two low power solutions for wireless systems with large antenna arrays, such as millimeter wave and massive MIMO systems. Most…
Analog-to-digital converters (ADCs) stand for a significant part of the total power consumption in a massive MIMO base station. One-bit ADCs are one way to reduce power consumption. This paper presents an analysis of the spectral efficiency…