Related papers: Equivalence of SLNR Precoder and RZF Precoder in D…
Signal-to-leakage-and-noise ratio (SLNR) is a promising criterion for linear precoder design in multi-user (MU) multiple-input multiple-output (MIMO) systems. It decouples the precoder design problem and makes closed-form solution…
Massive multiple-input multiple-output (MIMO) is a key technology for 5G wireless communications with a promise of significant capacity increase. The use of low-resolution data converters is crucial for massive MIMO to make the overall…
We consider a downlink multiuser multiple-input multiple output (MIMO) system employing regularized zero-forcing (RZF) precoding. We derive the asymptotic signal-to-leakage-plus-noise ratio (SLNR) as both the number of antennas and the…
In this letter, we consider linear precoding for downlink massive multi-user (MU) multiple-input multiple-output (MIMO) systems. We propose the novel successively-regularized zero forcing (SRZF) precoding, which exploits successive null…
By processing in the frequency domain (FD), massive MIMO systems can approach the theoretical per-user capacity using a single carrier modulation (SCM) waveform with a cyclic prefix. Minimum mean squared error (MMSE) detection and zero…
In this paper, we propose an enhanced leakage-based precoding scheme, i.e., layer signal to leakage plus noise ratio (layer SLNR) scheme, for multi-user multi-layer MIMO systems. Specifically, the layer SLNR scheme incorporates the MIMO…
In this paper, we consider the precoder design for an under-loaded or critically loaded downlink multi-user multiple-input multiple-output (MU-MIMO) communication system. We propose novel precoding and decoding schemes which enhance system…
We consider the downlink of a single-cell multi-user MIMO system in which the base station makes use of $N$ antennas to communicate with $K$ single-antenna user equipments (UEs) randomly positioned in the coverage area. In particular, we…
In this paper we first derived the mathematical expression for lower bound spectral efficiency (SE) calculation for zero-force (ZF), and minimum mean square error (MMSE). Secondly, we calculated the simulation SE with three algorithms for…
We address the problem of the bit error rate (BER) performance gap between the sub-optimal and optimal linear precoder (LP) for a multiuser (MU) multiple input and multiple output (MIMO) broadcast systems in this paper. Particularly, mobile…
We propose a max-min multi-cell aware regularized zero-forcing (Max-Min MCA-RZF) precoding and power allocation scheme for downlink multi-cell massive multiple-input multiple-output (MIMO) systems. A general correlated channel model is…
This paper analyzes the performance of linearly precoded time division duplex based multi-user massive MIMO downlink system under joint impacts of channel non-reciprocity (NRC) and imperfect channel state information (CSI). We consider a…
We consider the uplink of a multicell multiuser multiple-input multiple-output system where the channel experiences both small and large-scale fading. The data detection is done by using the linear zero-forcing technique, assuming the base…
Zero-forcing (ZF) precoding plays an important role for massive MIMO downlink due to its near optimal performance. However, the high computation cost of the involved matrix inversion hinders its application. In this paper, we adopt the…
In this paper, we analyze both the rate of convergence and the performance of a matched-filter (MF) precoder in a massive multi-user (MU) multiple-input-multiple-output (MIMO) system, with the aim of determining the impact of distributing…
We analyze the performance of multiple input/multiple output (MIMO) communications systems employing spatial multiplexing and zero-forcing detection (ZF). The distribution of the ZF signal-to-noise ratio (SNR) is characterized when either…
In multi-user multiple-input multiple-output (MU-MIMO) systems, the non-linear behavior of the power amplifiers (PAs) may cause degradation of the linear precoding schemes dealing with interference between user equipments (UEs), e.g., the…
Massive multi-user multiple-input multiple-output (MU-MIMO) enables significant gains in spectral efficiency and link reliability compared to conventional small-scale MIMO technology. Furthermore, linear precoders, e.g., using zero forcing…
In this paper, we consider massive multiple-input multiple-output (MIMO) systems for both downlink and uplink scenarios, where three radio units (RUs) connected via one digital unit (DU) support multiple user equipments (UEs) at the…
Feeding power amplifiers (PAs) with constant envelope (CE) signals is an effective way to reduce the power consumption in massive multiple-input-multiple-output (MIMO) systems. The nonlinear distortion caused by CE signaling must be…