Related papers: Robust Transceiver Design for AF MIMO Relay System…

We consider the downlink of a cell-free massive multiple-input multiple-output (MIMO) system with \textcolor{red}{single}-antenna access points (APs) and single-antenna users. An iterative robust minimum mean-square error (RMMSE) precoder…

The Compute-and-Forward relaying strategy achieves high computation rates by decoding linear combinations of transmitted messages at intermediate relays. However, if the involved relays independently choose which combinations of the…

In this paper, we consider massive multiple-input-multiple-output (MIMO) communication systems with a uniform planar array (UPA) at the base station (BS) and investigate the downlink precoding with imperfect channel state information (CSI).…

In this paper, we consider a multihop wireless sensor network (WSN) with multiple relay nodes for each hop where the amplify-and-forward (AF) scheme is employed. We present a strategy to jointly design the linear receiver and the power…

The integrated sensing and communication (ISAC) system under multi-input multi-output (MIMO) architecture achieves dual functionalities of sensing and communication on the same platform by utilizing spatial gain, which provides a feasible…

We consider the design of multiple-input multiple-output communication systems with a linear precoder at the transmitter, zero-forcing decision feedback equalization (ZF-DFE) at the receiver, and a low-rate feedback channel that enables…

This paper considers the performance of differential amplify-and-forward (D-AF) relaying over time-varying Rayleigh fading channels. Using the auto-regressive time-series model to characterize the time-varying nature of the wireless…

In this paper, we investigate the optimization problem of joint source and relay beamforming matrices for a twoway amplify-and-forward (AF) multi-input multi-output (MIMO) relay system. The system consisting of two source nodes and two…

This paper considers a multi-pair two-way amplify-and-forward relaying system, where multiple pairs of full-duplex users are served via a full-duplex relay with massive antennas, and the relay adopts maximum-ratio combining/maximum-ratio…

Despite the deleterious effect of hardware impairments on communication systems, most prior works have not investigated their impact on widely used relay systems. Most importantly, the application of inexpensive transceivers, being prone to…

In this work, we consider a dual-hop, decode-and-forward network where the relay can operate in full- duplex (FD) or half-duplex (HD) mode. We model the residual self-interference as an additive Gaussian noise with variance proportional to…

This paper proposes a roust downlink multiuser MIMO scheme that exploits the channel mean and antenna correlations to alleviate the performance penalty due to the mismatch between the true and estimated CSI.

We consider two-way amplify and forward relaying, where multiple full-duplex user pairs exchange information via a shared full-duplex massive multiple-input multiple-output (MIMO) relay. We derive closed-form lower bound for the spectral…

Owing to the vulnerability of relay-assisted and device-to-device (D2D) communications, improving wireless security from a physical layer signal processing perspective is attracting increasing interest. Hence we address the problem of…

We consider the opportunistic multiuser diversity in the multiuser two-way amplify-and-forward (AF) relay channel. The relay, equipped with multiple antennas and a simple zero-forcing beam-forming scheme, selects a set of two way relaying…

We Consider a multihop relay network in which two terminals are communicating with each other via a number of cluster of relays. Performance of such networks depends on the routing protocols employed. In this paper, we find the expressions…

We consider a two-hop Multiple-Input Multiple-Output channel with a source, a single Amplify and Forward relay, and the destination. We consider the problem of designing precoders at the source and the relay, and the receiver matrix at the…

Different from conventional passive reconfigurable intelligent surfaces (RISs), incident signals and thermal noise can be amplified at active RISs. By exploiting the amplifying capability of active RISs, noticeable performance improvement…

This paper considers a multiple-input multiple-output (MIMO) integrated sensing and communication (ISAC) system, where a multi-antenna base station (BS) with transceiver hybrid analog-digital arrays transmits dual-functional signals to…

We have evaluated the optimal secrecy rate for Amplify-and-Forward (AF) relay networks with multiple eavesdroppers. Assuming i.i.d. Gaussian noise at the destination and the eavesdroppers, we have devised technique to calculate optimal…