Related papers: Permeability changes in Boom clay with temperature
The thermal instability with a piecewise power law cooling function is investigated using one- and three-dimensional simulations with periodic and shearing-periodic boundary conditions in the presence of constant thermal diffusion and…
We present a non-invasive technique for measuring the thermal conductivity of fragile and sensitive materials. In the context of planet formation research, the investigation of the thermal conductivity of porous dust aggregates provide…
Water can be transitioned to an enhanced heat-conducting phase by supercooling only the water at the bottom of a container. The temperature gradient across the 4 cm in the center of an 8 cm long column of water with a 397 mW heat source at…
By computer numerical simulation of heating of a dust conducting particle in homogeneous plasma it was shown that depending on initial temperature of a particle both heating and cooling were possible with formation of two different…
We describe a set-up for studying adsorption of helium in silica aerogels, where the adsorbed amount is easily and precisely controlled by varying the temperature of a gas reservoir between 80 K and 180 K. We present validation experiments…
Permeability measured on three samples in a triaxial cell under effective confining pressure from 0.2 to 2.5 MPa ranges from 10E-18 to 10E-19m2. Overall, results indicate that permeability decreases with effective confining pressure up to…
The isochoric thermal conductivity of gama-O2 has been studied on samples of varying density in the temperature interval from 44 K to the onset of melting. The thermal conductivity of nearly free sample decreases at rising temperature along…
This article shows the importance of flow compressibility on the heat transfer in confined impinging jets, and how it is driven by both the Mach number and the wall heat-flux. Hence, we present a collection of cases at several Mach numbers…
The temperature dependence of hydrogen (H) desorption from Si(100) H-terminated surfaces by a scanning tunneling microscope (STM) is reported for negative sample bias. It is found that the STM induced H desorption rate ($R$) decreases…
Recent interest in Arctic exploration has brought new challenges concerning the mechanical behavior of lightweight materials for offshore structures. Exposure to seawater and cold temperatures are known to degrade the mechanical properties…
A micro-electro-mechanical system vibrating in its shear mode was used to study the viscosity of normal liquid $^3$He from 20mK to 770mK at 3bar, 21bar, and 29bar. The damping coefficient of the oscillator was determined by frequency sweeps…
The drilling of geothermal energy, CO2 sequestration, and wastewater injection all involve the pressurized flow of fluids through porous rock, which can cause deformation and fracture of the material. Despite the widespread use of these…
In order to study the penetration characteristics in areas with different water content and different stress distributions in the radial direction of the hole after hydraulicization measures, an improved LFTD1812 triaxial permeability meter…
We investigate the uncertainties affecting the temperature profiles of dense cores of interstellar clouds. In regions shielded from external ultraviolet radiation, the problem is reduced to the balance between cosmic ray heating, line…
This study investigates the effect of formulation, density and water content on the thermal conductivity of hemp concretes. The investigations are based on experimental measurements and on self-consistent scheme modelling. The thermal…
We study the effects of time-dependent substrate/film temperature in the deposition of a mesoscopically thick film using a statistical model that accounts for diffusion of adatoms without lateral neighbors whose coefficients depend on an…
The effect of pressure on structural and thermodynamic properties of ice Ih has been studied by means of path-integral molecular dynamics simulations at temperatures between 50 and 300 K. Interatomic interactions were modeled by using the…
Wettability is a pore-scale property that impacts the relative movement and distribution of fluids in a porous medium. There are reservoir fluids that provoke the surface within pores to undergo a wettability change. This wettability…
Ponds are universally used to store water for a large number of uses. With the increasing demand for more fresh water, ponds, lakes and reservoirs are likely to be constructed on a larger scale. We must understand the effects of…
The thermodynamics of hydration changes gradually from entropic for small solutes to enthalpic for large ones. The small-to-large crossover lengthscale of hydrophobic hydration depends on the thermodynamic conditions of the solvent such as…