Related papers: Joint Source and Relay Precoding Designs for MIMO …
In this paper, we consider the precoder design for an under-loaded or critically loaded downlink multi-user multiple-input multiple-output (MU-MIMO) communication system. We propose novel precoding and decoding schemes which enhance system…
In this work, we derive a lower bound on the training-based achievable downlink (DL) sum rate (SR) of a multi-user multiple-input-single-output (MISO) system operating in frequency-division-duplex (FDD) mode. Assuming linear minimum mean…
A MIMO secure two-hop wireless communication system is considered in this paper. In this model, there are no direct links between the source-destination and the source-eavesdropper. The problem is maximizing the secrecy capacity of the…
In this paper, a cooperative relay network consisting of a single-antenna source, a multi-antenna relay, and a multi-antenna destination is considered. The relay operates in decode-and-forward (DF) mode under frequency-selective fading. To…
Recent information theoretic results suggest that precoding on the multi-user downlink MIMO channel with delayed channel state information at the transmitter (CSIT) could lead to data rates much beyond the ones obtained without any CSIT,…
Signal-to-leakage-and-noise ratio (SLNR) is a promising criterion for linear precoder design in multi-user (MU) multiple-input multiple-output (MIMO) systems. It decouples the precoder design problem and makes closed-form solution…
Channel estimation and data transmission constitute the most fundamental functional modules of multiple-input multiple-output (MIMO) communication systems. The underlying key tasks corresponding to these modules are training sequence…
In this paper, we investigate the design of linear precoders for the multiple-input multiple-output (MIMO) multiple access channel (MAC). We assume that statistical channel state information (CSI) is available at the transmitters and…
Reconfigurable intelligent surface (RIS) has been anticipated to be a novel cost-effective technology to improve the performance of future wireless systems. In this paper, we investigate a practical RIS-aided multiple-input-multiple-output…
This paper presents a scalable beamforming design for maximizing the spectral efficiency (SE) of multi-reconfigurable intelligent surface (RIS)-aided communications through joint optimization of the precoder and RIS phase shifts in…
This paper considers an interference network composed of K half-duplex single-antenna pairs of users who wish to establish bi-directional communication with the aid of a multi-input-multi-output (MIMO) half-duplex relay node. This channel…
In future practical deployments of massive multi-input multi-output (MIMO) systems, the number of radio frequency (RF) chains at the base stations (BSs) may be much smaller than the number of BS antennas to reduce the overall expenditure.…
Reconfigurable intelligent surfaces (RISs) have huge potential to improve spectral and energy efficiency in future wireless systems at a minimal cost. However, early prototype results indicate that deploying hundreds or thousands of…
In this paper, we consider the problem of joint transmit precoding (TPC) matrix and receive filter matrix design subject to both secrecy and per-transmitter power constraints in the MIMO interference channel, where $K$ legitimate…
Multiple-input multiple-output (MIMO) systems greatly increase the overall throughput of wireless systems since they are capable of transmitting multiple streams employing the same time-frequency resources. However, this gain requires an…
This paper tackles the problem of the simultaneous interference among the multiple users in the downlink of a wireless multiantenna system. In order to exploit the multiuser interference and transform it into useful power at the receiver…
Practical multiple-input-multiple-output (MIMO) systems depend on a predefined set of precoders to provide spatial multiplexing gain. This limitation on the flexibility of the precoders affects the overall performance. Here, we propose a…
Efficient resource allocation with hybrid precoder design is essential for massive MIMO systems operating in millimeter wave (mmW) domain. Owing to a higher energy efficiency and a lower complexity of a partially connected hybrid…
Precoding techniques are key to dealing with multiuser interference in the downlink of cell-free (CF) multiple-input multiple-output systems. However, these techniques rely on accurate estimates of the channel state information at the…
In this paper we consider the problem of full-duplex multiple-input multiple-output (MIMO) relaying between multi-antenna source and destination nodes. The principal difficulty in implementing such a system is that, due to the limited…