Related papers: Effect of a thin AlO_x layer on transition-edge se…
A large-area thermoelectric generator (TEG) utilizing a folded thin-film concept is implemented and the performance evaluated for near room temperature applications having modest temperature gradients (< 50 K). The TEGs with the area of…
Superconducting transition temperatures Tc of the YBCO film surface and of the YBCO film/substrate interface were measured inductively. It was observed that the interface- Tc is always higher then the surface - Tc. However deposition of…
This study has successfully demonstrated a novel self-heating formaldehyde gas sensor based on a thin film of NiO sensing layer. A new fabrication process has been developed in which the Pt micro heater and electrodes are deposited directly…
Transition-edge sensors (TESs) can be used in high-resolution photon detection, exploiting the steep slope of the resistance in the superconducting-to-normal transition edge. Normal metal bars on the TES film are commonly used to engineer…
This study investigates the temperature-induced hysteretic behavior of resistivity and magnetoresistance in electrodeposited bismuth films, with a focus on their application as absorbers in transition-edge sensors (TESs) for X-ray…
Arrays of hundreds or thousands of low temperature detectors have been deployed for many experiments, both bolometers for long wavelength applications and calorimeters for shorter wavelength applications. One challenge that is common to…
We propose to operate a superconducting transition edge sensor (TES) using a different type of biasing, in which the resistance of the TES is kept constant by means of feedback on the bias voltage and is independent of the incoming signal…
Terahertz and sub-terahertz band detection has a key role both in fundamental interactions physics and technological applications, such as medical imaging, industrial quality control and homeland security. In particular, transition edge…
We are developing large TES arrays in combination with FDM readout for the next generation of X-ray space observatories. For operation under AC-bias, the TESs have to be carefully designed and optimized. In particular, the use of high…
We present X-ray absorption spectroscopy and resonant inelastic X-ray scattering (RIXS) measurements on the iron L-edge of 0.5 mM aqueous ferricyanide. These measurements demonstrate the ability of high-throughput transition-edge-sensor…
To improve both scalability and noise-filtering capability of a Transition-Edge Sensor (TES), a new concept of a thin-film detector is suggested, which is based on embedding a microbridge TES into a high-Q planar GHz range resonator weakly…
A number of electronic devices involve metal/oxide interfaces in their structure where the oxide layer plays the role of electrical insulator. As the downscaling of devices continues, the oxide thickness can spread over only a few atomic…
We describe a sensor for the measurement of thin dielectric layers capable of operation in a variety of environments. The sensor is obtained by microfabricating a capacitor with interleaved aluminum fingers, exposed to the dielectric to be…
Transition-edge sensors (TES) as microcalorimeters for high-energy-resolution X-ray spectroscopy are often fabricated with an absorber made of materials with high Z (for X-ray stopping power) and low heat capacity (for high resolving…
Transition-edge sensor (TES) is a highly sensitive device that is capable of detecting extremely low levels of energy. It is characterised by low noise performance and high energy resolution. A mature method for reading out TES signal is…
We investigate the crosstalk between Transition-Edge Sensor (TES) pixels in a prototype 24-pixel hard X-ray array fabricated at the Advanced Photon Source, Argonne National Laboratory. Analysis shows thermal cross talk, possibly associated…
Thermal-radiation detectors such as bolometers -- often found as thin, suspended films -- are intrinsically limited by their optical absorption properties and by their intrinsic thermal conductive and radiative losses. We analyze the impact…
The deposition of a thin oxide layer at metal/semiconductor interfaces has been previously reported as a means of reducing contact resistance in 2D electronics. Using X-ray photoelectron spectroscopy with in-situ Ti deposition, we fabricate…
We consider and compare candidate superconducting detector technologies that might be applied to the readout of cavity-axion haloscopes and similar fundamental physics experiments. We conclude that a transition edge sensor (TES) configured…
We theoretically predict and experimentally observe the onset of weak-link physics in the dynamical response of transition edge sensors (TES). We develop a theoretical framework based on a Fokker-Planck description that incorporates both…