Related papers: A General Robust Linear Transceiver Design for Mul…
We study in this paper a two-hop relaying network consisting of one source, one destination, and three amplify-and-forward (AF) relays operating in a half-duplex mode. In order to compensate for the inherent loss of capacity pre-log factor…
To improve signal-to-interference ratio (SIR) and make better use of file diversity provided by random caching, we consider two types of linear receivers, i.e., maximal ratio combining (MRC) receiver and partial zero forcing (PZF) receiver,…
In this paper, the design of robust linear precoders for the massive multi-input multi-output (MIMO) downlink with imperfect channel state information (CSI) is investigated. The imperfect CSI for each UE obtained at the BS is modeled as…
Affine frequency division multiplexing (AFDM) is a promising chirp-assisted multicarrier waveform for future high-mobility communications. This paper is devoted to enhanced receiver design for multiple input and multiple output AFDM…
Rate-splitting multiple access (RSMA) has been studied for multiuser multiple-input multiple-output (MUMIMO) systems especially in the presence of imperfect channel state information (CSI) at the transmitter. However, its precoding designs…
This paper addresses precoder design for secure multiple-input multiple-output (MIMO) integrated sensing and communications (ISAC) systems. We introduce a MIMO channel with a multiple-antenna eavesdropper and a multiple-antenna sensing…
Due to the continuous advancements of orthogonal frequency division multiplexing (OFDM) and multiple antenna techniques, multiuser multiple input multiple output (MU-MIMO) OFDM is a key enabler of both fourth and fifth generation networks.…
In this paper, we consider the problem of joint transceiver design for millimeter wave (mmWave)/Terahertz (THz) multi-user MIMO integrated sensing and communication (ISAC) systems. Such a problem is formulated into a nonconvex optimization…
In this paper, we investigate a multiple-input multiple-output (MIMO) integrated sensing and communication (ISAC) system under typical block-fading channels. As a non-trivial extension to most existing works on ISAC, both the training and…
This paper addresses the joint transceiver design, including pilot transmission, channel feature extraction and feedback, as well as precoding, for low-overhead downlink massive multiple-input multiple-output (MIMO) communication in…
We study a multiple-input multiple-output (MIMO) multiple access channel (MAC) from several multi-antenna transmitters to a multi-antenna receiver. The fading channels between the transmitters and the receiver are modeled by random…
This paper considers a multiple input multiple output (MIMO) two-way relay channel, where two nodes want to exchange data with each other using multiple relays. An iterative algorithm is proposed to achieve the optimal achievable rate…
In this paper, we study the performance of an amplify-and-forward (AF) based analog network coding (ANC) relay scheme in a multi-hop wireless network under individual power constraints. In the first part, a unicast scenario is considered.…
This paper investigates the performance of optimal single stream beamforming schemes in multiple-input multiple-output (MIMO) dual-hop amplify-and-forward (AF) systems. Assuming channel state information is not available at the source and…
Since the introduction of massive MIMO (mMIMO), the design of a transceiver with feasible complexity has been a challenging problem. Initially, it was believed that the main issue in this respect is the overall RF-cost. However, as mMIMO is…
Two-way relaying networks (TWRNs) allow for more bandwidth efficient use of the available spectrum since they allow for simultaneous information exchange between two users with the assistance of an intermediate relay node. However, due to…
This letter investigates a downlink multiple input single output (MISO) system based on transmissive reconfigurable metasurface (RMS) transmitter. Specifically, a transmitter design based on a transmissive RMS equipped with a feed antenna…
An adaptive joint power allocation (JPA) and linear receiver design algorithm using the minimum bit error rate (MBER) criterion for a cooperative Multiple-Input Multiple-Output (MIMO) network is proposed. The system employs multiple relays…
The stringent performance requirements of future wireless networks, such as ultra-high data rates, extremely high reliability and low latency, are spurring worldwide studies on defining the next-generation multiple-input multiple-output…
In this paper, we propose a robust transceiver design for the K-pair quasi-static MIMO interference channel. Each transmitter is equipped with M antennas, each receiver is equipped with N antennas, and the k-th transmitter sends L_k…