Related papers: Nanostructuring of Ba8Ga16Ge30 clathrates
Thermoelectric effects enable the direct conversion between thermal and electrical energy and provide an alternative route for power generation and refrigeration. The clathrate Ba8Ga16Ge30 has the highest figure of merit (ZT ~ 1) among…
Thermoelectric properties of the type-I clathrates Ba$_8$Cu$_x$Si$_{46-x}$ ($3.6 \leq x \leq 7$, $x$ = nominal Cu content) are investigated both experimentally and theoretically. The polycrystalline samples are prepared either by melting,…
We report the electrical resistivity, Hall coefficient, thermoelectric power, specific heat, and thermal conductivity on single crystals of the type-VIII clathrate Ba8Ga16Sn30 grown from Sn-flux. Negative S and R_H over a wide temperature…
Intermetallic clathrates are candidate materials for thermoelectric applications above room temperature. Here we explore whether their intrinsically low lattice thermal conductivities can be further reduced by nanostructuring and whether…
We have grown single crystals of the type-VIII intermetallic clathrate Ba8Ga16Sn30 from both Sn and Ga flux, evaluated their compositions through electron microprobe analysis and studied their transport properties through measurements on…
The thermoelectric properties of two typical SiGe nanotubes are investigated using a combination of density functional theory, Boltzmann transport theory, and molecular dynamics simulations. Unlike carbon nanotubes, these SiGe nanotubes…
Critical thermoelectric parameters including Seebeck coefficient, electrical conductivity, thermal conductivity and figure of merit ZT of one-dimensional coaxial Bi2Te3/Sb2Te3 nanocomposite were modeled by following the single carrier…
Type-I clathrates with a cage structure are known to be of importance for thermoelectric applications as the cage can be filled with a guest atom which leads to reduced thermal conductivity. Among the type-I clathrates, Si-based alloys are…
A ternary type-I Si clathrate, K8AlxSi46-x, which is a candidate functional material composed of abundant non-toxic elements, was synthesized and its transport properties were investigated at temperatures ranging from 10 to 320 K. The…
The efficiency of energy conversion in thermoelectric generators (TEGs) is directly proportional to electrical conductivity and Seebeck coefficient while inversely to thermal conductivity. The challenge is to optimize these interdependent…
Understanding the covalent clathrate formation is a crucial point for the design of new superhard materials with intrinsic coupling of superhardness and metallic conductivity. Silicon clathrates have the archetype structures that can serve…
We have prepared samples of nominal type Ba(8)Cu(x)Ge(46-x) by induction melting and solid state reaction. Analysis shows that these materials form type-I clathrates, with copper content between x = 4.9 and 5.3, nearly independent of the…
Iron oxide nano particles with nominal Fe2O3 stoichiometry were synthesized by a wet, soft chemical method with the heat treatment temperatures from 250{\deg}C to 900{\deg}C in air. The variation in the structural properties of the nano…
Inelastic neutron scattering measurements are utilized to explore relative changes in the generalized phonon density of states of nanocrystalline Si1xGex thermoelectric materials prepared via ball milling and hot-pressing techniques.…
The structural and electronic properties of the clathrate compounds Ba$_{8}$Al$_{x}$Si$_{46-x}$ and Sr$_{8}$Al$_{x}$Si$_{46-x}$ are studied from first principles, considering an Al content $x$ between 6 and 16. Due to the large number of…
For simultaneously achieving the high-power factor and low lattice thermal conductivity of Si-Ge based thermoelectric materials, we employed, in this study, constructively modifying the electronic structure near the chemical potential and…
In the ternary system Sr-Cu-Ge, a clathrate type-I phase, Sr8Cu5.3Ge40.7 (a = 1.06311(3), exists close to the Zintl limit in a small temperature interval. Sr8Cu5.3Ge40.7 decomposes eutectoidally on cooling at 730{\deg}C into (Ge), SrGe2 and…
We report here metal to insulator transition, colossal Seebeck coefficient and ultralow thermal conductivity (0.0057th of its bulk value, significantly smaller than many well-known thermoelectric materials and silicon, showing potential…
A nanopowder from p-Bi-Sb-Te with particles ~ 10 nm were fabricated by the ball milling using different technological modes. Cold and hot pressing at different conditions and also SPS process were used for consolidation of the powder into a…
As a result of suppressed phonon conduction, large improvements of the thermoelectric figure of merit, ZT, have been recently reported for nanostructures compared to the raw materials' ZT values. It has also been suggested that low…