Related papers: Novel Scintillation Material - ZnO Transparent Cer…
As grown ZnO:Si nanocomposite films fabricated by thermal evaporation showed broad photoluiminescence (PL) spectra due to merging of four prominent peaks viz 370, 410, 470 and 520 nm. Investigations revealed the role of interface in…
Liquid xenon is an important detection medium in direct dark matter experiments, which search for low-energy nuclear recoils produced by the elastic scattering of WIMPs with quarks. The two existing measurements of the relative…
Due to its wide band gap and high carrier mobility, ZnO is an attractive material for light-harvesting and optoelectronic applications. Its functional efficiency, however, is strongly affected by defect-related in-gap states that open up…
Cryogenic operation in conjunction with new test-mass materials promises to reduce the sensitivity limitations from thermal noise in gravitational-wave detectors. The currently most advanced materials under discussion are crystalline…
We report interesting observations in 1.2 MeV Ar8+ ion irradiated ZnO which, to the best of our knowledge, have not been published earlier and will be useful for the scientific community engaged in research on ZnO. Irradiation with the…
Scintillator detectors can be used in experiments searching for neutrinoless double beta decay. A wide variety of double beta decay candidate isotopes can be made into scintillators or can be loaded into scintillators. Experimental programs…
NiO/ZnO-based thin films, including single-layer and heterostructure configurations, were synthesized to investigate the influence of stacking order on their electrochemical performance for supercapacitor applications. To improve the…
Zinc telluride (ZnTe) thin films have special semiconducting characteristics that make them very promising for a broad range of optoelectronic applications. In this work, a novel approach for synthesizing ZnTe thin films by spin coating…
In this paper Al doped ZnO (AZO) thin films with 0, 3, 6 and 12 at. % Al concentration were prepared by sol-gel method on glass substrates. The deposited films were annealed at different temperatures of 300, 350, 400, 450 and 500 {\deg}C…
Recently, d0 ferromagnetic materials have been projected as one of the promising novel materials for spintronics applications. In this work, we have studied Li-doped ZnO compounds, i.e. Zn1-xLixO (x=0, 0.02, 0.04, and 0.06) samples,…
Sr doped ZnO nanorods thin films are prepared using wet chemical technique on transparent flexible substrate. Effect of Sr doping on structural and optical properties of ZnO is systematically investigated. The sensing property of the ZnO is…
Scaling of transistors has enabled continuous improvements in logic device performance, especially through materials engineering. However, surpassing horizontal limitations in chip manufacturing requires a vertical, third dimension.…
Lithium magnesium molybdate (Li$_2$Mg$_2$(MoO$_4$)$_3$) crystals were grown by the low-thermal-gradient Czochralski method. Luminescence properties of the material (emission spectra, thermally stimulated luminescence, dependence of…
Noble metals such as gold and silver are the primary metallic building blocks of metamaterial devices. Making subwavelength-sized structural elements from these metals seriously limits the optical performance of a device, however, and…
Dark matter detectors that utilize liquid xenon have now achieved tonne-scale targets, giving them sensitivity to all flavours of supernova neutrinos via coherent elastic neutrino-nucleus scattering. Considering for the first time a…
The study uses AACVD technology with nitrogen carrier gas to make AZO thin films through which it determines structural, optical, and morphological changes from 0 to 20 percent aluminum doping. The depositions took place at 400 degrees…
The SNO+ experiment is the follow up of the SNO experiment, replacing the heavy water volume with about 780 tons of liquid scintillator (LAB) in order to shift the sensitive threshold to lower energy range. The 6000 m.w.e. natural rock…
Photodetectors (PDs) are essential in imaging, communication, and sensing technologies. However, their reliance on external power makes them energy-consuming. This creates a strong need for self-powered PDs as a sustainable alternative. ZnO…
Acoustic haptic technology adds touch sensations to human-machine interfaces by integrating piezoelectric actuators onto touchscreens. Traditional piezoelectric haptic technologies use opaque lead-containing ceramics that are both toxic and…
A new experiment based on tin-loaded scintillator is proposed to measure the 2nu double beta decay half-life of Sn-124 for the first time. Measurements of long term stabilitiy and optical properties of the produced scintillator are…