Related papers: Robust Beamforming in Interference Channels with I…
This paper considers beamforming for a reconfigurable intelligent surface (RIS)-aided multiple input single output (MISO) communication system in the presence of Rician multipath fading. Our aim is to jointly optimize the transmit…
This paper studies the wireless two-way relay channel (TWRC), where two source nodes, S1 and S2, exchange information through an assisting relay node, R. It is assumed that R receives the sum signal from S1 and S2 in one time-slot, and then…
This paper studies fast downlink beamforming algorithms using deep learning in multiuser multiple-input-single-output systems where each transmit antenna at the base station has its own power constraint. We focus on the…
A two-phase beamforming solution for secure communication using untrusted relay nodes is presented. To thwart eavesdropping attempts of relay nodes, we deliberately introduce artificial noise in the source message. After pointing out the…
Cooperative beamforming (CB) has been proposed as a special case of coordinated multi-point techniques in wireless communications. In wireless sensor networks, CB can enable low power communication by allowing a collection of sensor nodes…
This paper studies the transmit beamforming in a downlink integrated sensing and communication (ISAC) system, where a base station (BS) equipped with a uniform linear array (ULA) sends combined information-bearing and dedicated radar…
This work gives a blind beamforming strategy for intelligent reflecting surface (IRS), aiming to boost the received signal-to-noise ratio (SNR) by coordinating phase shifts across reflective elements in the absence of channel information.…
Magnetic resonant coupling (MRC) is an efficient method for realizing the near-field wireless power transfer (WPT). The use of multiple transmitters (TXs) each with one coil can be applied to enhance the WPT performance by focusing the…
The tremendous capacity gains promised by space division multiple access (SDMA) depend critically on the accuracy of the transmit channel state information. In the broadcast channel, even without any network interference, it is known that…
In this paper, the robust distributed relay beamforming problem is solved using the worst case approach, where the problem solution has been involved because of the effect of uncertainty of channel knowledge on the quality of service (QoS)…
Multiple transmit antennas in a downlink channel can provide tremendous capacity (i.e. multiplexing) gains, even when receivers have only single antennas. However, receiver and transmitter channel state information is generally required. In…
We introduce, design, and evaluate a set of universal receiver beamforming techniques. Our approach and system DEFORM, a Deep Learning (DL) based RX beamforming achieves significant gain for multi antenna RF receivers while being agnostic…
In this letter, we propose a robust beamforming design for non-orthogonal multiple access (NOMA) based multiple-input single-output (MISO) downlink systems. In particular, the robust power minimization problem is studied with imperfect…
This paper considers the setup of a parallel MIMO relay network in which $K$ relays, each equipped with $N$ antennas, assist the transmitter and the receiver, each equipped with $M$ antennas, in the half-duplex mode, under the assumption…
Physical wireless transceivers suffer from a variety of impairments that distort the transmitted and received signals. Their degrading impact is particularly evident in modern systems with multiuser transmission, high transmit power, and…
Coherent communications aim to support higher data rates and extended connectivity at lower power consumption compared with traditional point-to-point transmissions. The typical setting of coherent communication schemes is based on a single…
In order to address the asynchronous interference issue for a generalized scenario with multiple primary and multiple secondary receivers, in this paper, we propose an innovative cooperative beamforming technique. In particular, the…
In this paper, we focus on intelligent reflecting surface (IRS) assisted multi-antenna communications with transceiver hardware impairments encountered in practice. In particular, we aim to maximize the received signal-to-noise ratio (SNR)…
Magnetic induction (MI) communication is an effective underground emergency communication technique after disasters such as landslides, mine collapses, and earthquakes, due to its advantages in mediums such as soil, concrete, and metals.…
A receiver with perfect channel state information (CSI) in a point-to-point multiple-input multiple-output (MIMO) channel can compute the transmit beamforming vector that maximizes the transmission rate. For frequency-division duplex, a…