Related papers: Reduced-Dimension Multiuser Detection
The purpose of remote sensing image change detection (RSCD) is to detect differences between bi-temporal images taken at the same place. Deep learning has been extensively used to RSCD tasks, yielding significant results in terms of result…
This letter proposes a deep learning-based data-aided active user detection network (D-AUDN) for grant-free sparse code multiple access (SCMA) systems that leverages both SCMA codebook and Zadoff-Chu preamble for activity detection. Due to…
This paper proposes a new method to monitor and mitigate fault induced delayed voltage recovery (FIDVR) phenomenon in distribution systems using {\mu}PMU measurements in conjunction with a Reduced Distribution System Model (RDSM). The…
This work provides a generalized performance analysis for the multi-user uplink-NOMA system with adaptive square quadrature amplitude modulation (QAM) over Rayleigh fading channels. Motivated by the massive IoT connections and…
Radio frequency (RF) signals have facilitated the development of non-contact human monitoring tasks, such as vital signs measurement, activity recognition, and user identification. In some specific scenarios, an RF signal analysis framework…
In this work we examine blind adaptive and iterative decision feedback (DF) receivers for direct sequence code division multiple access (DS-CDMA) systems in frequency selective channels. Code-constrained minimum variance (CMV) and constant…
Full-duplex (FD) systems have emerged as an es- sential enabling technology to further increase the data rate of wireless communication systems. The key idea of FD is to serve multiple users over the same bandwidth with a base station (BS)…
With the ever-increasing user density and quality of service (QoS) demand,5G networks with limited spectrum resources are facing massive access challenges. To address these challenges, in this paper, we propose a novel discrete semantic…
Technologies for mmWave communication are at the forefront of investigations in both industry and academia, as the mmWave band offers the promise of orders of magnitude additional available bandwidths to what has already been allocated to…
This paper considers an uplink massive machine-type communication (mMTC) scenario, where a large number of user devices are connected to a base station (BS). A novel grant-free massive random access (MRA) strategy is proposed, considering…
Fast rate adaptation has been established as an effective way to improve the PHY-layer raw date rate of wireless networks. However, within the current IEEE 802.11 legacy, MAC-layer throughput is dominated by users with the lowest data…
In multiple-input multiple-output (MIMO) spatially multiplexing (SM) systems, achievable error rate performance is determined by signal detection strategy. The optimal maximum-likelihood detection (MLD) that exhaustively examines all symbol…
To fully utilize the spatial multiplexing gains or array gains of massive MIMO, the channel state information must be obtained at the transmitter side (CSIT). However, conventional CSIT estimation approaches are not suitable for FDD massive…
This paper studies the detection and performance analysis problems for a relay network with $N$ parallel decode-and-forward (DF) relays. Due to the distributed nature of this network, it is practically very challenging to fulfill the…
A space-time adaptive decision feedback (DF) receiver using recurrent neural networks (RNN) is proposed for joint equalization and interference suppression in direct-sequence code-division-multiple-access (DS-CDMA) systems equipped with…
This paper is focused on multiuser load modulation arrays (MU-LMAs) which are attractive due to their low system complexity and reduced cost for millimeter wave (mmWave) multi-input multi-output (MIMO) systems. The existing precoding…
Distributed radar sensors enable robust human activity recognition. However, scaling the number of coordinated nodes introduces challenges in feature extraction from large datasets, and transparent data fusion. We propose an end-to-end…
Providing reliable service to users close to the edge between cells remains a challenge in cellular systems, even as 5G deployment is around the corner. These users are subject to significant signal attenuation, which also degrades their…
Single user massive multiple input multiple output (MIMO) can be used to increase the spectral efficiency, since the data is transmitted simultaneously from a large number of antennas located at both the base station and mobile. It is…
Digital receivers are required to recover the transmitted symbols from their observed channel output. In multiuser multiple-input multiple-output (MIMO) setups, where multiple symbols are simultaneously transmitted, accurate symbol…