Related papers: RF-thermal-structural-RF coupled analysis on the t…

Use of a traveling wave (TW) accelerating structure with a small phase advance per cell instead of standing wave may provide a significant increase of accelerating gradient in a superconducting linear accelerator. The TW section achieves an…

Early tests of short low group velocity and standing wave structures indicated the viability of operating X-band linacs with accelerating gradients in excess of 100 MeV/m. Conventional scaling of traveling wave traveling wave linacs with…

The Standing Wave (SW) TESLA niobium-based superconducting radio frequency structure is limited to an accelerating gradient of about 50 MV/m by the critical RF magnetic field. To break through this barrier, we explore the option of…

We have explored a concept for an advanced Normal-Conducting Radio-Frequency (NCRF) C-band linear accelerator (linac) structure to achieve a high gradient, high power e$^+$e$^-$ linear collider in the TeV class. This design study represents…

The millimeter wave all-metallic accelerating structure, aimed to provide more than 100 MeV/m gradient and fed by feeding RF pulses of 20-30 ns duration, is proposed. The structure is based on a waveguide with small helical corrugation.…

We have performed Linearized Augmented Plane Wave (LAPW) calculations for five crystal structures (alpha, dhcp, sc, fcc, bcc) of Boron which we then fitted to a non-orthogonal tight-binding model following the Naval Research Laboratory…

Use of a superconducting traveling wave accelerating (STWA) structure with a small phase advance per cell rather than a standing wave structure may provide a significant increase of the accelerating gradient in the ILC linac. For the same…

The wire method is a more rapid and less costly method to measure impedances of RF components compared to methods using a beam. A setup using a single displaced wire to excite and measure transverse resonant modes in accelerating structures…

Dielectric-loaded accelerating (DLA) structures are being studied as an alternative to conventional disk-loaded copper structures to produce the high accelerating gradient. This paper presents the design, fabrication and low-power RF…

Non-linear simulation results for a 220-GHz rectangular dielectric-loaded traveling wave amplifier are presented. Simulations are used to check a linear theory that is developed by phenomenological introduction of an effective dielectric…

For the CLIC two-beam scheme, a high-current, long-pulse drive beam is required for RF power generation. Taking advantage of the 3 GHz klystrons available at the LEP injector once LEP stops, a 180 MeV electron accelerator is being…

High-gradient linacs of next generation require novel accelerating structures which are compact, robust and cost-effective. Dedicated research and development have been launched in the linear-collider community. This paper focuses on the…

Dipole wakefields in NLC (Next Linear Collider) structures have been measured with ASSET [1] and well predicted by a circuit model [2]. However, the experimental technique is both time-consuming and expensive. Here, we report on kick factor…

We have developed high-efficiency normal-conducting RF accelerating structures by combining H-mode resonator cavities and a transverse beam focusing by permanent-magnet quadrupoles (PMQ), for beam velocities in the range of a few percent of…

RF processing studies of 1.8-m X-band (11.4 GHz) traveling wave structures at the Next Linear Collider Test Accelerator (NLCTA) have revealed breakdown-related damage at gradients lower than expected from earlier tests with standing wave…

In the framework of the upgrade of the SPARC_LAB facility at INFN-LNF, named EuPRAXIA@SPARC_LAB, a high gradient linac is foreseen. One of the most suitable options is to realize it in X-band. A preliminary design study of both accelerating…

A 162.5 MHz, 2.1 MeV Radio Frequency Quadruples (RFQ) structure is being designed for the Injector Scheme II of China Accelerator Driver System (CADS) driver linac. The RFQ will operate at continuous wave (CW) mode as required. For the CW…

This paper outlines the RF design of the CLIC (Compact Linear Collider) 30 GHz main linac accelerating structure and gives the resulting longitudinal and transverse mode properties. The critical requirement for multibunch operation, that…

Kinetic inductance travelling wave parametric amplifiers (KI-TWPAs) have been simulated using Keysight's Advanced Design System (ADS). A lumped element representation of a superconducting transmission line has been developed using nonlinear…

The Disk Loaded Waveguide (DLW) is the mostly used high frequency structure for acceleration of lightweight particles - electrons in the high energy range. In some physical experiments acceleration of more heavy particles - muons to medium…