Related papers: Characterizing a fiber-based frequency comb with e…
We report a multi-channel optical frequency synthesizer developed to generate extremely stable continuous wave lasers directly out of the optical comb of an Er-doped fiber oscillator. Being stabilized to a high-finesse cavity with a…
Opto-mechanical oscillators that generate coherent acoustic waves are drawing much interest, in both fundamental research and applications. Narrowband oscillations can be obtained through the introduction of feedback to the acoustic wave.…
We demonstrate a 0.95 GHz repetition rate fully stabilized Yb:fiber frequency comb without optical amplification. Benefitted from the high mode power and high coherence, this comb achieved 35 dB to 42 dB signal to noise ratio on the direct…
Laser frequency combs are fast becoming critical to reaching the highest radial velocity precisions. One shortcoming is the highly variable brightness of the comb lines across the spectrum (up to 4-5 orders of magnitude). This can result in…
We experimentally study a fiber loop laser with an integrated Erbium doped fiber (EDF). The output optical spectrum is measured as a function of the EDF temperature. We find that below a critical temperature of about 10K the measured…
We synchronize a 8.06-GHz microwave signal from a voltage-controlled oscillator with an optical pulse train from a 77.5- MHz mode-locked Er-fiber laser using a fiber-based optical-microwave phase detector. The residual phase noise between…
Optical frequency combs generated by multiple four-wave mixing of two stabilized single-frequency lasers in optical fibers are proposed for use as high precision frequency markers, calibration of astrophysical spectrometers and metrology.…
We use two fiber-based femtosecond frequency combs and a low-noise carrier suppression phase detection system to characterize the optical to microwave synchronization achievable with such frequency divider systems. By applying specific…
High-resolution ultrasound based imaging techniques like photoacoustic (PA) imaging that require fast detection of acoustic waves, are often coupled with an opto-mechanical sensor like a Fabry-Perot cavity (FPC) for enhanced sensitivity at…
We demonstrate efficient generation of mid-infrared frequency combs based on continuous-wave-seeded femtosecond optical parametric generation in nonlinear waveguides. Conversion of the near-infrared pump to signal and idler light takes…
The outstanding phase-noise performance of optical frequency combs has led to a revolution in optical synthesis and metrology, covering a myriad of applications, from molecular spectroscopy to laser ranging and optical communications.…
Optical frequency combs are revolutionising modern time and frequency metrology. In the past years, their range of applications has increased substantially, driven by their miniaturisation through microresonator-based solutions. The combs…
We present detailed numerical simulations of the laser dynamics that describe optical frequency comb formation by injection-locking a gain-switched laser. The typical rate equations for semiconductor lasers including stochastic carrier…
We study a re-configurable nonreciprocal fiber ring cavity setup to generate tunable optical frequency combs. Coherent combs can be obtained by finely exploiting bi-chromatic Brillouin lasing and cascaded four-wave mixing in the nonlinear…
Electro-optic phase modulators are critical components in modern communication, microwave photonic, and quantum photonic systems. Important for these applications is to achieve modulators with low half-wave voltage at high frequencies. Here…
We characterized and analyzed the effect of intracavity spectral filtering in the Er:fiber laser mode-locked with a semiconductor saturable absorber mirror (SESAM). We studied the dispersive properties of bandpass filters and their…
Frequency combs enable precision measurements across timekeeping, spectroscopy, ranging and astronomy, and are now extending to integrated and field-deployable platforms. Realizing their full performance demands a comprehensive account of…
Design of a mid-wave IR (MWIR) broad-band fiber-based light source exploiting four-wave mixing (FWM) in a meter long suitably designed highly nonlinear (NL) chalcogenide microstructured optical fiber (MOF) is reported. This superior FWM…
Multi-color solitons that are parametrically created in dual-pumped microresonators generate interleaved frequency combs that can be used to obtain combs at new frequencies and when synchronized can be used for low-noise microwave…
Laser intensity noise is a main limitation of measurement and sensing mission represented by gravitational wave detection. We develop a noise decomposition model and design the core elements of the feedback loop independently based on the…