Related papers: Distributed MAC Protocol Supporting Physical-Layer…
Direct application of network coding at the physical layer - physical layer network coding (PNC) - is a promising technique for two-way relay wireless networks. In a two-way relay network, relay nodes are used to relay two-way information…
Physical-layer network coding (PNC) is a communications paradigm that exploits overlapped transmissions to boost the throughput of wireless relay networks. A high point of PNC research was a theoretical proof that PNC that makes use of…
We design a cross-layer approach to aid in develop- ing a cooperative solution using multi-packet reception (MPR), network coding (NC), and medium access (MAC). We construct a model for the behavior of the IEEE 802.11 MAC protocol and apply…
Interference in wireless networks is one of the key-capacity limiting factor. The multicast capacity of an ad- hoc wireless network decreases with an increasing number of transmitting and/or receiving nodes within a fixed area. Digital…
A node equipped with a multi-beam antenna can achieve a throughput of up to m times as compared to a single-beam antenna, by simultaneously communicating on its m non-interfering beams. However, the existing multi-beam medium access control…
This work investigates the maximum broadcast throughput and its achievability in multi-hop wireless networks with half-duplex node constraint. We allow the use of physical-layer network coding (PNC). Although the use of PNC for unicast has…
Wireless communications using light waves are called visible light communication. A technique called Physical-layer Network coding allows several users to communicate simultaneously over the same channel in a distributed space-time Coding…
In this work, we propose buffer-aided physical-layer network coding (PLNC) techniques for cooperative direct-sequence code-division multiple access systems. In the proposed buffer-aided PLNC schemes, a relay pair selection algorithm is…
The growing demand for high-speed data, quality of service (QoS) assurance and energy efficiency has triggered the evolution of 4G LTE-A networks to 5G and beyond. Interference is still a major performance bottleneck. This paper studies the…
The two-phase MIMO NC (network coding) scheme can be used to boost the throughput in a two-way relay channel in which nodes are equipped with multiple antennas. The obvious strategy is for the relay node to extract the individual packets…
The feasibility of practical in-band full-duplex radios has recently been demonstrated experimentally. One way to leverage full-duplex in a network setting is to enable three-node full-duplex, where a full- duplex access point (AP)…
Distributed medium access control (MAC) protocols are essential for the proliferation of low cost, decentralized wireless local area networks (WLANs). Most MAC protocols are designed with the presumption that nodes comply with prescribed…
This paper studies the problem of transmitting multiple independent layered video streams over single-hop wireless networks using network coding (NC). We combine feedback-free random linear NC (RLNC) with unequal error protection (UEP) and…
Distributed medium access control (MAC) protocols are proposed for wireless networks assuming that one-hop peers can periodically exchange a small amount of state information. Each station maintains a state and makes state transitions and…
Fifth generation (5G) wireless networks will need to serve much higher user densities than existing 4G networks, and will therefore require an enhanced radio access network (RAN) infrastructure. Physical layer network coding (PNC) has been…
In this paper, we investigate the joint optimal sensing and distributed Medium Access Control (MAC) protocol design problem for cognitive radio (CR) networks. We consider both scenarios with single and multiple channels. For each scenario,…
A key issue in physical-layer network coding (PNC) is how to deal with the asynchrony between signals transmitted by multiple transmitters. That is, symbols transmitted by different transmitters could arrive at the receiver with symbol…
We describe a new synchronous and distributed medium access control (MAC) protocol for multihop wireless networks that provides bandwidth guarantees to unicast connections. Our MAC protocol is based on a slotted time division multiple…
This paper presents the first implementation of a two-way relay network based on the principle of physical-layer network coding. To date, only a simplified version of physical-layer network coding (PNC) method, called analog network coding…
This paper investigates the application of physical-layer network coding (PNC) to Industrial Internet-of-Things (IIoT) where a controller and a robot are out of each other's transmission range, and they exchange messages with the assistance…