Related papers: Heat loads and cryogenics for HE-LHC
Measurements of the heat capacity C(T,H) of the one-dimensional quantum magnet TiOCl are presented for temperatures 2K < T < 300K and magnetic fields up to 5T. Distinct anomalies at 91K and 67K signal two subsequent phase transitions. The…
BaH (and its isotopomers) is an attractive molecular candidate for laser cooling to ultracold temperatures and a potential precursor for the production of ultracold gases of hydrogen and deuterium. The theoretical challenge is to simulate…
The Large Hadron Collider (LHC) at CERN will provide proton-proton collisions at a centre-of-mass energy of 14 TeV with a design luminosity of 10**34/cm**2/s. The exploitation of the rich physics potential offered by the LHC will be…
We developed a soft and high thermal conductive heat link for cryogenic applications. The measured maximum thermal conductivity was approximately 18500 W/m/K at 10 K. This spring constant was 1/43 of that of a single thick wire with the…
Multi Layer Capacitors MLCs are considered as the most promising refrigerant elements to design and develop electrocaloric cooling devices. Recently, the heat transfer of these MLCs has been considered. However, the heat exchange with the…
The LHC is made of eight circular arcs interspaced with eight Long Straight Sections (LSS). Most powering interfaces to the LHC are located in these sections where the particle beams are focused and shaped for collision, cleaning and…
While the CMS experiment is currently harvesting LHC collision data at CERN, the performance of its electromagnetic calorimeter (ECAL) is being constantly monitored, and work has started to assess the need for changes to the detector to…
The Gersemi cryogenic test bench, installed at FREIA laboratory at Uppsala University, was used for the first time in 2021 to power a superconducting magnet. As part of the HL-LHC program, this cryostat offers an operating temperature…
A cryogenic horizontal single loop target has been designed, built, tested and operated for the G$^0$ experiment in Hall C at Jefferson Lab. The target cell is 20 cm long, the loop volume is 6.5 l and the target operates with the cryogenic…
Particle accelerators with superconducting magnets operating at cryogenic temperatures use a beam screen (BS) liner that extracts heat generated by the circulating bunched charge particle beam before it can reach the magnets. The BS…
Laser cooling of nuclear beams in storage rings is discussed. The main properties of nuclei with isomeric levels in the range E<50 keV are presented.
The performance of the CMS electromagnetic calorimeter upgraded readout electronics, developed for the High-Luminosity phase of the LHC, is discussed. Data collected in two beam test campaigns conducted in 2018 and 2021 at the H4 and H2…
Chapter 5 in High-Luminosity Large Hadron Collider (HL-LHC) : Preliminary Design Report. The Large Hadron Collider (LHC) is one of the largest scientific instruments ever built. Since opening up a new energy frontier for exploration in…
The LHCb experiment at CERN has been upgraded for the Run 3 operation of the Large Hadron Collider (LHC). A new concept of tracking detector based on Scintillating Fibres (SciFi) read out with multichannel silicon photomultipliers (SiPMs)…
It is known that 3D-ICs suffer from hot spot temperatures that can reach thousands of degrees, if they are not cooled to reasonable operating temperatures. The problem of hot spots is not limited to the high temperatures of the IC; thermal…
The CMS Collaboration is preparing to build replacement endcap calorimeters for the HL-LHC era. The new high-granularity calorimeter (HGCAL) is, as the name implies, a highly-granular sampling calorimeter with approximately six million…
The CMS experiment at the CERN LHC will be upgraded to accommodate the 5-fold increase in the instantaneous luminosity expected at the High-Luminosity LHC (HL-LHC). Concomitant with this increase will be an increase in the number of…
Chapter 8 in High-Luminosity Large Hadron Collider (HL-LHC) : Preliminary Design Report. The Large Hadron Collider (LHC) is one of the largest scientific instruments ever built. Since opening up a new energy frontier for exploration in…
In the described device, the thermal emissivity or absorptivity of the sample is measured by substitution of the radiative heat flow between two parallel surfaces by thermal output of a heater. Fast measurements of the mutual emissivity for…
This is the third out of five chapters of the final report [1] of the Workshop on Physics at HL-LHC, and perspectives on HE-LHC [2]. It is devoted to the study of the potential, in the search for Beyond the Standard Model (BSM) physics, of…